One is a streaming all-in-one and the other is an amplifier. Judge them on how many boxes you want and what you already own, not on the spec sheet alone.
| Area | Better | Why |
|---|
| Power | A | NAD C 368 BluOS-2i has more power - 80W against 50W into 8 ohms. That is about 2dB, so it plays usefully louder before it runs out and has more in hand on peaks. |
| Room size | depends | We rate NAD C 368 BluOS-2i the better fit for a mid-size room, a large room and a very large room, and Audiolab 6000A for desk or near-field listening and a small room. Match the amplifier to the room you actually have, not the one you want. |
| Grip on hard loads | B | Audiolab 6000A holds up better into a 4-ohm load: its output increases strongly to 75W, where the other barely increases. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | A | NAD C 368 BluOS-2i is the quieter design on paper - 98dB against 76dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | evenly matched | Both have a DAC on board with much the same capability. |
| Streaming | A | Only NAD C 368 BluOS-2i has AirPlay 2, Roon and BluOS. |
| Analogue inputs | B | Audiolab 6000A takes more analogue sources - 4 against 2. |
| Room to grow | B | Only Audiolab 6000A offers a pre-out/main-in loop - which decides whether you can add a subwoofer or a power amplifier later without replacing the box. |
| Amplifier class | depends | NAD C 368 BluOS-2i is Class D and Audiolab 6000A is Class A/B. Class D runs cool and draws almost nothing at idle; Class A/B runs warm and is the long-established mainstream choice. Modern examples of both measure well - judge by the rest of the page. |
| Price | B | Audiolab 6000A costs less - $899 against $1,998 at list. |
| Watts per dollar | B | Audiolab 6000A is the cheaper watt - about $18 per watt against $25. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A NAD C 368 BluOS-2i B Audiolab 6000A
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
Audiolab 6000A has the edge on paper, though not by much. The rows marked "depends" are more likely to decide this than the score is. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Audiolab 6000A is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. Start with the room. In a large or open-plan room, or with speakers that are hard to drive - low sensitivity, or an impedance that dips - NAD C 368 BluOS-2i has the headroom, and headroom is what stops an amplifier hardening up on peaks. At desk distance or in a small room, 50 watts is already more than most people ever use, and the extra 30 watts would be headroom you pay for and never hear - we rate NAD C 368 BluOS-2i poorly for near-field use for exactly that reason.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.