These are not the same size of amplifier: Michi X5 Series 2 has roughly 3.1x the power of Mark Levinson No.5805. That is about 4.9dB, so it is a question of room size and how hard your speakers are to drive, not of one being the better amplifier.
| Area | Better | Why |
|---|
| Power | B | Michi X5 Series 2 has more power - 390W against 125W into 8 ohms. That is about 4.9dB, so it plays usefully louder before it runs out and has more in hand on peaks. |
| Room size | depends | We rate Mark Levinson No.5805 the better fit for desk or near-field listening, a small room and a mid-size room, and Michi X5 Series 2 for a very large room. Match the amplifier to the room you actually have, not the one you want. |
| Grip on hard loads | A | Mark Levinson No.5805 holds up better into a 4-ohm load: its output nearly doubles to 250W, where the other increases strongly. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | evenly matched | Much the same signal-to-noise ratio (103dB vs 102dB). |
| Built-in DAC | evenly matched | Both have a DAC on board with much the same capability. |
| Streaming | evenly matched | Only Michi X5 Series 2 has Roon. Neither list is longer in a way that matters - check the one service you actually pay for. |
| Analogue inputs | B | Michi X5 Series 2 takes more analogue sources - 5 against 3. |
| Room to grow | evenly matched | The same expansion options on both. |
| Price | B | Michi X5 Series 2 costs less - $9,499 against $10,500 at list. |
| Watts per dollar | B | Michi X5 Series 2 is the cheaper watt - about $24 per watt against $84. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A Mark Levinson No.5805 B Michi X5 Series 2
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
Michi X5 Series 2 has the edge on paper, though not by much. The rows marked "depends" are more likely to decide this than the score is. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Mark Levinson No.5805 is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. Start with the room. In a large or open-plan room, or with speakers that are hard to drive - low sensitivity, or an impedance that dips - Michi X5 Series 2 has the headroom, and headroom is what stops an amplifier hardening up on peaks. At desk distance or in a small room, 125 watts is already more than most people ever use, and the extra 265 watts would be headroom you pay for and never hear - we rate Michi X5 Series 2 poorly for near-field use for exactly that reason.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.