No single best amplifier here. What decides it is what you have to drive, what you need to plug in, and how much of the system you want in one box.
| Area | Better | Why |
|---|
| Power | B | Arcam A15 has more power - 80W against 45W into 8 ohms. That is about 2.5dB, so it plays usefully louder before it runs out and has more in hand on peaks. |
| Room size | depends | We rate Marantz PM6007 the better fit for desk or near-field listening and a small room, and Arcam A15 for a mid-size room, a large room and a very large room. Match the amplifier to the room you actually have, not the one you want. |
| Grip on hard loads | B | Arcam A15 holds up better into a 4-ohm load: its output increases strongly to 120W, where the other increases modestly. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | B | Arcam A15 is the quieter design on paper - 106dB against 102dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | evenly matched | Both have a DAC on board with much the same capability. |
| Analogue inputs | A | Marantz PM6007 takes more analogue sources - 4 against 3. |
| Room to grow | A | Only Marantz PM6007 offers a subwoofer output - which decides whether you can add a subwoofer or a power amplifier later without replacing the box. |
| Price | A | Marantz PM6007 costs less - $899 against $999 at list. |
| Watts per dollar | B | Arcam A15 is the cheaper watt - about $12 per watt against $20. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A Marantz PM6007 B Arcam A15
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
The usual trade-off: Arcam A15 measures better, Marantz PM6007 costs about 10% less. With most speakers in most rooms that gap is smaller in practice than it looks here. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Arcam A15 is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. Start with the room. In a large or open-plan room, or with speakers that are hard to drive - low sensitivity, or an impedance that dips - Arcam A15 has the headroom, and headroom is what stops an amplifier hardening up on peaks. At desk distance or in a small room, 45 watts is already more than most people ever use, and the extra 35 watts would be headroom you pay for and never hear - we rate Arcam A15 poorly for near-field use for exactly that reason.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.