One is a streaming all-in-one and the other is an amplifier. Judge them on how many boxes you want and what you already own, not on the spec sheet alone.
| Area | Better | Why |
|---|
| Power | B | NAD C 388 BluOS-2i has more power - 150W against 100W into 8 ohms. That is about 1.8dB, which is a small step in loudness but real headroom on peaks. |
| Room size | depends | We rate Audiolab 9000A the better fit for desk or near-field listening, a small room and a mid-size room, and NAD C 388 BluOS-2i for a very large room. Match the amplifier to the room you actually have, not the one you want. |
| Grip on hard loads | A | Audiolab 9000A holds up better into a 4-ohm load: its output increases strongly to 160W, where the other barely increases. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | A | Audiolab 9000A is the quieter design on paper - 110dB against 95dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | A | Both decode on board, but only Audiolab 9000A handles DSD and MQA. |
| Streaming | B | Only NAD C 388 BluOS-2i has AirPlay 2, Roon and BluOS. |
| Analogue inputs | A | Audiolab 9000A takes more analogue sources - 3 against 2. |
| Room to grow | A | Only Audiolab 9000A offers a pre-out/main-in loop - which decides whether you can add a subwoofer or a power amplifier later without replacing the box. |
| Amplifier class | depends | Audiolab 9000A is Class A/B and NAD C 388 BluOS-2i is Class D. Class A/B runs warm and is the long-established mainstream choice; Class D runs cool and draws almost nothing at idle. Modern examples of both measure well - judge by the rest of the page. |
| Shelf space | depends | Audiolab 9000A takes up about 17% less shelf area (1518cm² against 1840cm²), and it is 81mm shallower, which is the measurement that decides whether a rack door shuts. |
| Price | B | NAD C 388 BluOS-2i costs less - $2,249 against $2,999 at list. |
| Watts per dollar | B | NAD C 388 BluOS-2i is the cheaper watt - about $15 per watt against $30. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A Audiolab 9000A B NAD C 388 BluOS-2i
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
The usual trade-off: Audiolab 9000A measures better, NAD C 388 BluOS-2i costs about 25% less. With most speakers in most rooms that gap is smaller in practice than it looks here. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Audiolab 9000A is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. Think about the whole system: the roughly $750 saved by taking the cheaper one would buy better speakers or a subwoofer, which does more for the sound than the difference between two competent amplifiers.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.