No single best amplifier here. What decides it is what you have to drive, what you need to plug in, and how much of the system you want in one box.
| Area | Better | Why |
|---|
| Power | B | NAD C 379 has more power - 80W against 50W into 8 ohms. That is about 2dB, so it plays usefully louder before it runs out and has more in hand on peaks. |
| Grip on hard loads | A | Audiolab 6000A MKII holds up better into a 4-ohm load: its output increases strongly to 75W, where the other barely increases. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | A | Audiolab 6000A MKII is the quieter design on paper - 110dB against 95dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | B | Both decode on board. NAD C 379 goes higher - 384kHz against 192kHz. Very few recordings exist above 192kHz, so treat this as headroom, not as sound quality. |
| Room to grow | A | Only Audiolab 6000A MKII offers a pre-out/main-in loop - which decides whether you can add a subwoofer or a power amplifier later without replacing the box. |
| Amplifier class | depends | Audiolab 6000A MKII is Class A/B and NAD C 379 is Class D. Class A/B runs warm and is the long-established mainstream choice; Class D runs cool and draws almost nothing at idle. Modern examples of both measure well - judge by the rest of the page. |
| Shelf space | depends | Audiolab 6000A MKII takes up about 27% less shelf area (1328cm² against 1810cm²), and it is 117mm shallower, which is the measurement that decides whether a rack door shuts. |
| Price | A | Audiolab 6000A MKII costs less - $1,099 against $1,499 at list. |
A Audiolab 6000A MKII B NAD C 379
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
Audiolab 6000A MKII has the edge on paper, though not by much. The rows marked "depends" are more likely to decide this than the score is. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Audiolab 6000A MKII is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. Start with the room. In a large or open-plan room, or with speakers that are hard to drive - low sensitivity, or an impedance that dips - NAD C 379 has the headroom, and headroom is what stops an amplifier hardening up on peaks. At desk distance or in a small room, 50 watts is already more than most people ever use, and the extra 30 watts would be headroom you pay for and never hear.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.