These are not the same size of amplifier: Rotel Diamond RA-6000 has roughly 2x the power of Marantz Model 30. That is about 3dB, so it is a question of room size and how hard your speakers are to drive, not of one being the better amplifier.
| Area | Better | Why |
|---|
| Power | A | Rotel Diamond RA-6000 has more power - 200W against 100W into 8 ohms. That is about 3dB, so it plays usefully louder before it runs out and has more in hand on peaks. |
| Room size | depends | We rate Rotel Diamond RA-6000 the better fit for a very large room, and Marantz Model 30 for desk or near-field listening, a small room and a mid-size room. Match the amplifier to the room you actually have, not the one you want. |
| Grip on hard loads | B | Marantz Model 30 holds up better into a 4-ohm load: its output nearly doubles to 200W, where the other increases strongly. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | A | Rotel Diamond RA-6000 is the quieter design on paper - 103dB against 88dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | A | Rotel Diamond RA-6000 has a DAC on board; the other needs an external one, which is another box, another power lead and another purchase. |
| Streaming | evenly matched | Only Rotel Diamond RA-6000 has Roon. Neither list is longer in a way that matters - check the one service you actually pay for. |
| Analogue inputs | B | Marantz Model 30 takes more analogue sources - 6 against 4. |
| Room to grow | evenly matched | The same expansion options on both. |
| Amplifier class | depends | Rotel Diamond RA-6000 is Class A/B and Marantz Model 30 is Class D. Class A/B runs warm and is the long-established mainstream choice; Class D runs cool and draws almost nothing at idle. Modern examples of both measure well - judge by the rest of the page. |
| Price | B | Marantz Model 30 costs less - $2,999 against $4,500 at list. |
| Watts per dollar | A | Rotel Diamond RA-6000 is the cheaper watt - about $23 per watt against $30. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A Rotel Diamond RA-6000 B Marantz Model 30
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
The usual trade-off: Rotel Diamond RA-6000 measures better, Marantz Model 30 costs about 33% less. With most speakers in most rooms that gap is smaller in practice than it looks here. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Marantz Model 30 is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. Start with the room. In a large or open-plan room, or with speakers that are hard to drive - low sensitivity, or an impedance that dips - Rotel Diamond RA-6000 has the headroom, and headroom is what stops an amplifier hardening up on peaks. At desk distance or in a small room, 100 watts is already more than most people ever use, and the extra 100 watts would be headroom you pay for and never hear - we rate Rotel Diamond RA-6000 poorly for near-field use for exactly that reason.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.