One is a streaming all-in-one and the other is an amplifier. Judge them on how many boxes you want and what you already own, not on the spec sheet alone.
| Area | Better | Why |
|---|
| Power | B | Naim CI-Uniti 102 has more power - 150W against 100W into 8 ohms. That is about 1.8dB, which is a small step in loudness but real headroom on peaks. |
| Room size | depends | We rate NAD C 3050 the better fit for desk or near-field listening, a small room and a mid-size room, and Naim CI-Uniti 102 for a very large room. Match the amplifier to the room you actually have, not the one you want. |
| Grip on hard loads | B | Naim CI-Uniti 102 holds up better into a 4-ohm load: its output increases strongly to 260W, where the other barely increases. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | B | Naim CI-Uniti 102 is the quieter design on paper - 110dB against 95dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | B | Both decode on board. Naim CI-Uniti 102 goes higher - 384kHz against 192kHz. Very few recordings exist above 192kHz, so treat this as headroom, not as sound quality. |
| Streaming | evenly matched | Only Naim CI-Uniti 102 has Chromecast. Neither list is longer in a way that matters - check the one service you actually pay for. |
| Analogue inputs | A | NAD C 3050 takes more analogue sources - 2 against 1. |
| Phono stage | depends | NAD C 3050 has a built-in phono stage (MM) and Naim CI-Uniti 102 does not. Decisive if you own a turntable, completely irrelevant if you do not - and an outboard phono stage is easy to add later either way. |
| Room to grow | evenly matched | The same expansion options on both. |
| Headphones | depends | Only NAD C 3050 has a headphone output. Worth something if you listen late, nothing if you never do. |
| Shelf space | depends | Naim CI-Uniti 102 takes up about 45% less shelf area (900cm² against 1638cm²), and it is 64mm shallower, which is the measurement that decides whether a rack door shuts. |
| Price | B | Naim CI-Uniti 102 costs less - $1,499 against $1,799 at list. |
| Watts per dollar | B | Naim CI-Uniti 102 is the cheaper watt - about $10 per watt against $18. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A NAD C 3050 B Naim CI-Uniti 102
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
Naim CI-Uniti 102 is the easier recommendation: it leads on most of the measured areas and costs less. Take NAD C 3050 if one of the "depends" rows above describes your system. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Naim CI-Uniti 102 is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. If you play records, NAD C 3050 saves you buying a phono stage; if you do not, ignore that row entirely.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.