Different price classes - Arcam SA20 costs roughly 1.7x what Arcam A15 does. Expect it to lead on paper; the question is whether you will hear the difference through the speakers you own.
| Area | Better | Why |
|---|
| Power | evenly matched | Effectively the same output - 80W against 90W into 8 ohms is under 1dB, which is not an audible difference in loudness. |
| Grip on hard loads | B | Arcam SA20 holds up better into a 4-ohm load: its output increases strongly to 150W, where the other increases strongly. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | evenly matched | Much the same signal-to-noise ratio (106dB vs 106dB). |
| Built-in DAC | evenly matched | Both have a DAC on board with much the same capability. |
| Analogue inputs | B | Arcam SA20 takes more analogue sources - 4 against 3. |
| Room to grow | evenly matched | The same expansion options on both. |
| Amplifier class | depends | Arcam A15 is Class A/B and Arcam SA20 is Class G. Class A/B runs warm and is the long-established mainstream choice; Class G/H switches its supply rails to cut the heat a Class A/B design wastes. Modern examples of both measure well - judge by the rest of the page. |
| Price | A | Arcam A15 costs less - $999 against $1,650 at list. |
| Watts per dollar | A | Arcam A15 is the cheaper watt - about $12 per watt against $18. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A Arcam A15 B Arcam SA20
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
Arcam SA20 is ahead, but on only 1 of the measured areas, and it costs about 65% more. That is a lot of money for a narrow margin - Arcam A15 is the sensible buy unless a specific feature above decides it for you. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Arcam SA20 is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. Think about the whole system: the roughly $651 saved by taking the cheaper one would buy better speakers or a subwoofer, which does more for the sound than the difference between two competent amplifiers.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.