Perlisten A3m LCR is a 3-way Passive Bass Reflex Center Channel speaker by Perlisten. It was released in 2023. Center channel speaker is an important component of a home theater system set-up as it delivers the listener significant part of the on-screen dialogue from your television. It features a Tweeter and x " Woofer. Perlisten lists the drivers as Tweeter: 35mm composite Teteron dome Woofers: (2) 215mm carbon fiber diaphragm. The speaker has a frequency range of 41-30k Hz and a sensitivity of 87.4 dB. Perlisten A3m LCR has an MSRP of 3590$ per pair.
Room Size Suitability
The size of the room where you plan to use the Perlisten A3m LCR is a crucial factor in your decision. We have assessed its suitability for various room sizes based on its dimensions and maximum power output:
| Listening Environment* |
Suitability |
| Near-field | Good |
| Small Room | Good |
| Mid-size Room | Average |
| Large Room | Poor |
| Very Large Room | No way |
(* Approximate Room sizes: Small < 100sq. ft / 9 m2, Mid-size: 100-220 sq. ft / 9-20 m2, Large 220-400 sq. ft / 20-36 m2, Very Large: > 400 sq. ft / 36 m2.
Average Floor Height: 9" / 2.7m. Typical room sizes differ from country to country, and the actual listening experience changes depending on floor height, room shape, surface materials, listening position, speaker locations, etc.)
Frequency Response of the Perlisten A3m LCR Speaker
Perlisten A3m LCR has a Frequency response range of 41-30k Hz and Power Range of 50 – 250W watts.
Here we have a comparison of how A3m LCR's Low frequency value compares with the average, max and min Low frequency values in its class.
Low Frequency
Center Channel Speakers
Impedance and Sensitivity
Perlisten A3m LCR's nominal impedance level is
4 ohms but can go down to as low as
3 ohms, and has a sensitivity of
87.4 dB.
Sensitivity
Center Channel Speakers
Nominal Impedance of the 4 Ohms means that the Perlisten A3m LCR is a difficult to drive speaker from nominal Impedance perspective, make sure that you choose an amplifier than can provide 4 Ohms for this speaker.
Many AVRs (audio/video receiver) in the market may have difficulty when the speakers dip below the 4 Ohms levels (this may cause clipping or even physical damage), so we recommend to not pair the Perlisten A3m LCR with an AVR but use an Integrated Amplifier instead.
Sensitivity
With a sensitivity level of only 87 dB, Perlisten A3m LCR is a difficult to drive speaker from Sensitivity perspective, make sure to choose an amplifier with a high output if you like listening to your music at high volume levels. You may especially have a hard time using Tube amplifiers which are traditionally very low power compared to Class A/B or Class D amps. Work out how loud the Perlisten A3m LCR plays in your room →
Running more than one pair from a single amplifier? Check the load it would present →
Minimum Impedance of the Perlisten A3m LCR
Even though the nominal impedance of the A3m LCR is 4 ohms, the minimum impedance level of this speaker according to Perlisten is 3 ohms Perlisten A3m LCR so while choosing an amplifier, you should ideally check if the unit you are considering can provide this impedance level.
What amplifier does the Perlisten A3m LCR need?
At normal listening levels in a medium room, about
30–250 W
per channel into 4 ohms.
Set your own conditions and we will rank every amplifier we cover.
Prefer to browse? Integrated amplifiers under $5,000, or every amplifier we cover.
Input Type
A3m LCR features Binding post type connectors.
Work out what gauge speaker cable this run needs →
Perlisten A3m LCR External Dimensions and Weight
Perlisten A3m LCR has external dimensions of (Height x Width x Depth) 26.57 x 11.02 x 13.78inch (674.9 x 279.9 x 350.0mm ).
Base Surface Area
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base area of Perlisten A3m LCR is approximately 979.7cm2 / 151.9inch2.
Find speakers that fit your shelf or alcove →
Cabinet type and Materials
Perlisten A3m LCR has a
Bass Reflex type cabinet. Bass Reflex type loudspeakers (aka Ported, Vented or Reflex Port) have enclosures that uses a port, hole or vent cut into the cabinet. Ported designs are generally more efficient than the Sealed designs.
Does the Perlisten A3m LCR come with a Grille?
A3m LCR comes with grilles. The purpose of the grille is to protect the delicate driver elements from external impacts while still allowing the sound to pass as clearly as possible.
Recommended Accessories
Here is a list of accessories that we think you may need for the Perlisten A3m LCR.
Official Product Page
Official manufacturer's product page for the Perlisten A3m LCR speaker can be found below:
Official Product Page for Perlisten A3m LCR