The DAC-R8 is a headphone amplifier by Eversolo. It was released in November 2026. It has a built-in DAC (Eversolo OriginR2R discrete R2R, 5+20-bit, FPGA controlled, fully differential), so you can play digital sources directly with no separate DAC unit needed. The DAC-R8 has an MSRP of $1,280.
Performance Specs
The DAC-R8 drives headphones rather than loudspeakers, so its power is quoted into headphone impedances instead of into 8 ohms: 1 W @ 16 ohms, 1 W @ 32, 160 mW @ 300 (high gain); single-ended 6.35 mm only. Eversolo quotes a THD (Total Harmonic Distortion) of 0.000287% @ 1 kHz (headphone out, high gain); 0.000316% XLR line out (lower is better).
Here are the main highlights of its performance specs:
- 127dB Signal to Noise Ratio
Inputs and Outputs
Besides the performance specs of the DAC-R8, the next important feature set that you have to evaluate is the input and output selections that it offers.
Inputs
- 1 Optical Digital Input
- 1 Coaxial Digital Input
- USB Input:
Outputs
- Preamp Outputs
- Balanced XLR Output
- 1/4 Headphone Output
Bluetooth Connectivity
DAC-R8 features built-in Bluetooth 5.4 for wireless music streaming from your Bluetooth-enabled devices such as Apple iPod/iPhone/iPad, Android smartphone/tablet, Windows PC, Mac computers/laptops.
Among the amps in the same price range, these are the 5 amps that have Bluetooth Connectivity:
DAC-R8 supports the following Bluetooth Codecs when used with supported devices:
- aptX
- aptX HD
- aptX Adaptive
Phono Input
DAC-R8 doesn't have a phono input so in order to play your vinyl albums, DAC-R8 has to be paired with a Phono Preamp that is MM (Moving Magnet) or/and MC (Moving COil) depending on your cartridge type.
Balanced connections
DAC-R8 has a balanced XLR output. A balanced cable carries the signal twice, on two conductors of opposite polarity. Interference picked up along the way lands on both equally and cancels when the two are recombined at the far end, so the longer the cable run and the noisier the surroundings, the more the connection is worth. On a headphone output the other benefit is separation: a balanced connector gives each channel its own return conductor instead of the two sharing a common ground, which lowers crosstalk between left and right. Whether a balanced connection also yields more power depends on how the amplifier is built inside - some are balanced end to end, others convert to single-ended internally and deliver the same power either way, so it is worth reading the maker's own wording rather than assuming.
DAC and Digital Music
The DAC-R8's built-in DAC allows the connection of digital sources directly, eliminating the need for an external DAC. The DAC chip that is used in the DAC-R8 is the
Eversolo OriginR2R discrete R2R, 5+20-bit, FPGA controlled, fully differential.
DAC-R8 Pros and Cons
Drawn from the published figures on this page, not from listening.
- ✓Delivers 1,000 mW into 32 ohms, comfortably more than most headphones need.
- ✓A preamp output means it can also feed active speakers or a power amplifier, so it is not limited to headphone listening.
- ✓A built-in DAC takes a digital source directly, with no separate converter to buy or find space for.
- ✗It has no speaker terminals - this drives headphones, not loudspeakers.
DAC-R8 External Dimensions and Weight
DAC-R8 has external dimensions of (H x W x D) 2-15/16 x 12-3/8 x 9-1/16 inch (75 x 315 x 230 mm ). The unit weighs
4 kg (8.8 lbs).
Base Surface Area
Base surface area of an integrated amplifier may become an important decision factor when the space in your room or desk is limited.
The base area of the DAC-R8 is approximately 724.5cm2 / 112.3inch2.
- Width: 315.0mm (12-3/8")
- Height: 75.0mm (2-15/16")
- Depth: 230.0mm (9-1/16")
- Weight: 4 kg (8.8 lbs)
- Base Surface Area: ~724.5cm2 / 112.3inch2
- Volume: ~5.4 liter / 1.4 gallon
Official Product Page
Official manufacturer's product page for the Eversolo DAC-R8 Integrated Amplifier can be found below:
Official Product Page for DAC-R8
| General |
| Brand |
Eversolo |
| Full Model Name |
Eversolo DAC-R8 |
| Release Date |
November 2026 |
| Amplifier Type |
Headphone Amplifier |
| Amplifier Technology |
Solid State |
| Performance |
| Headphone Output Power |
1 W @ 16 ohms, 1 W @ 32, 160 mW @ 300 (high gain); single-ended 6.35 mm only |
| Output Impedance |
N/A |
| Frequency Bandwidth |
20 Hz-20 kHz |
| THD |
0.000287% @ 1 kHz (headphone out, high gain); 0.000316% XLR line out |
| Signal to Noise Ratio |
127 dB |
| Digital Music |
| Built-in DAC |
Yes |
| DAC Specs |
Eversolo OriginR2R discrete R2R, 5+20-bit, FPGA controlled, fully differential |
| Bluetooth |
Yes |
| WiFi |
No |
| CONNECTIONS |
| Total Analog Inputs |
0 |
| Phono Input |
No |
| Optical Digital Inputs |
1 |
| Coaxial Digital Inputs |
1 |
| USB Input |
Yes |
| USB Type |
USB-B |
| Preamp Outputs |
Yes |
| Balanced XLR Output |
Yes |
| Headphone Output |
1/4 |
| Removable Power Cord |
|
| PHYSICAL SPECS |
| Height |
75.0mm (2-15/16") |
| Width |
315.0mm (12-3/8") |
| Depth |
230.0mm (9-1/16") |
| Weight |
4 kg (8.8 lbs) |
| OTHER |
| Screen |
Yes |
| Parts Warranty |
|
| Labor Warranty |
|
Does the DAC-R8 use vacuum tubes?
No. The DAC-R8 is a solid-state amplifier - there are no vacuum tubes in it.
Does the DAC-R8 have a built-in DAC?
Yes. The DAC-R8 has a built-in DAC (Eversolo OriginR2R discrete R2R, 5+20-bit, FPGA controlled, fully differential), so you can feed it a digital source directly without buying a separate converter.
Can I connect a turntable to the DAC-R8?
No. The DAC-R8 has no phono input, so a turntable needs an external phono preamp (or a deck with one built in) before it can be connected.
Does the DAC-R8 have Bluetooth?
Yes. The DAC-R8 supports Bluetooth (Bluetooth 5.4 and the aptX, aptX HD, aptX Adaptive codec), so you can stream straight from a phone, tablet or laptop.
Does the DAC-R8 have a headphone output?
Yes. The DAC-R8 has a 1/4-inch headphone output on the front panel for private listening.
How much does the DAC-R8 cost?
The DAC-R8 has a manufacturer's list price (MSRP) of $1,280.
Was this amplifier review useful?
Tell us what is missing or wrong and we will fix it.