One is a streaming all-in-one and the other is an amplifier. Judge them on how many boxes you want and what you already own, not on the spec sheet alone.
| Area | Better | Why |
|---|
| Power | evenly matched | Effectively the same output - 120W against 100W into 8 ohms is under 1dB, which is not an audible difference in loudness. |
| Grip on hard loads | A | Rotel RA-1572 MKII holds up better into a 4-ohm load: its output increases strongly to 200W, where the other barely increases. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | A | Rotel RA-1572 MKII is the quieter design on paper - 100dB against 90dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | A | Both decode on board. Rotel RA-1572 MKII goes higher - 384kHz against 192kHz. Very few recordings exist above 192kHz, so treat this as headroom, not as sound quality. |
| Streaming | B | Only NAD Masters Series M10 V2 has AirPlay 2 and BluOS. |
| Analogue inputs | A | Rotel RA-1572 MKII takes more analogue sources - 4 against 2. |
| Phono stage | depends | Rotel RA-1572 MKII has a built-in phono stage (MM) and NAD Masters Series M10 V2 does not. Decisive if you own a turntable, completely irrelevant if you do not - and an outboard phono stage is easy to add later either way. |
| Use with a TV | depends | Only NAD Masters Series M10 V2 has HDMI eARC, so the television can drive it directly and one remote controls the volume. If the system is for music only, this changes nothing. |
| Room to grow | evenly matched | The same expansion options on both. |
| Headphones | depends | Only Rotel RA-1572 MKII has a headphone output. Worth something if you listen late, nothing if you never do. |
| Amplifier class | depends | Rotel RA-1572 MKII is Class A/B and NAD Masters Series M10 V2 is Class D. Class A/B runs warm and is the long-established mainstream choice; Class D runs cool and draws almost nothing at idle. Modern examples of both measure well - judge by the rest of the page. |
| Shelf space | depends | NAD Masters Series M10 V2 takes up about 64% less shelf area (606cm² against 1675cm²), and it is 108mm shallower, which is the measurement that decides whether a rack door shuts. |
| Price | A | Rotel RA-1572 MKII costs less - $2,100 against $2,499 at list. |
| Watts per dollar | A | Rotel RA-1572 MKII is the cheaper watt - about $18 per watt against $25. A blunt measure, and it says nothing about how either sounds, but it is the honest one for raw output. |
A Rotel RA-1572 MKII B NAD Masters Series M10 V2
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
Rotel RA-1572 MKII is the easier recommendation: it leads on most of the measured areas and costs less. Take NAD Masters Series M10 V2 if one of the "depends" rows above describes your system. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Rotel RA-1572 MKII is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating. If you play records, Rotel RA-1572 MKII saves you buying a phono stage; if you do not, ignore that row entirely.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.