One is a streaming all-in-one and the other is an amplifier. Judge them on how many boxes you want and what you already own, not on the spec sheet alone.
| Area | Better | Why |
|---|
| Power | evenly matched | Effectively the same output - 50W against 50W into 8 ohms is under 1dB, which is not an audible difference in loudness. |
| Grip on hard loads | B | Audiolab 6000A holds up better into a 4-ohm load: its output increases strongly to 75W, where the other barely increases. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | A | NAD C 338 is the quieter design on paper - 98dB against 76dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | evenly matched | Both have a DAC on board with much the same capability. |
| Streaming | evenly matched | Only NAD C 338 has Chromecast. Neither list is longer in a way that matters - check the one service you actually pay for. |
| Analogue inputs | B | Audiolab 6000A takes more analogue sources - 4 against 2. |
| Room to grow | B | Only Audiolab 6000A offers a pre-out/main-in loop - which decides whether you can add a subwoofer or a power amplifier later without replacing the box. |
| Amplifier class | depends | NAD C 338 is Class D and Audiolab 6000A is Class A/B. Class D runs cool and draws almost nothing at idle; Class A/B runs warm and is the long-established mainstream choice. Modern examples of both measure well - judge by the rest of the page. |
| Shelf space | depends | NAD C 338 takes up about 16% less shelf area (1349cm² against 1605cm²), and it is 49mm shallower, which is the measurement that decides whether a rack door shuts. |
| Price | A | NAD C 338 costs less - $799 against $899 at list. |
A NAD C 338 B Audiolab 6000A
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
The usual trade-off: Audiolab 6000A measures better, NAD C 338 costs about 11% less. With most speakers in most rooms that gap is smaller in practice than it looks here. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Audiolab 6000A is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.