In this review, we will be comparing Airmotiv XT1 and C 95 II, two Passive Floor-standing speakers from Emotiva and Jamo. Let's have a brief look at the main features
of Emotiva Airmotiv XT1 and Jamo C 95 II first before getting into our more
detailed comparison.
What size room are the Emotiva Airmotiv XT1 and Jamo C 95 II speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the Emotiva Airmotiv XT1 and Jamo C 95 II compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
One of the fundamental differences between these two speakers is that Airmotiv XT1 is a 3-way design whereas the C 95 II is a 2-way speaker. 3-way designs utilize a midrange driver in addition to the tweeter and woofer on 2-way designs. Designing a crossover for a 3-way speaker is a complicated process and generally increases the overall cost of the speaker.
| Driver |
Emotiva Airmotiv XT1 |
Jamo C 95 II |
|
Driver Setup
|
3-way
|
2-way
|
|
Tweeter
|
25×32 mm-inch
|
1-inch
|
|
Midrange
|
1 x 4.5-inch |
- |
|
Woofer
|
3 x 5.25-inch
|
2 x 6-inch
|
Airmotiv XT1 features a 25×32 mm" folded ribbon Tweeter , a 4.5" Midrange and 3 x 5.25" woven fiber cone Woofer with a Crossover frequency at 410 Hz, 3.1 kHz. On the other hand, the C 95 II features a 1" Tweeter and 2 x 6" Composite Woofer .
Frequency Response
Airmotiv XT1 has a frequency range of 45 Hz – 27 kHz whereas C 95 II has a frequency range of 37-24k Hz. With a minimum frequency of 37Hz, the C 95 II can go significantly deeper on the low side and provide stronger bass compared to the Airmotiv XT1's min frequency of 45Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Floor-standing class in our database.
Low Frequency
Floor-standing Speakers
High Frequency
Floor-standing Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Airmotiv XT1 is a 4 ohms speaker compared to the C 95 II which has a nominal impedance of 6 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Airmotiv XT1 can provide this impedance level.
On the other hand, they have the same sensitivity of 89 dBdB.
Sensitivity
Floor-standing Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Airmotiv XT1 can handle a max power of 200 watts RMS from the amp the whereas C 95 II has a max power handling value of 165 watts RMS, 35 watts less than the Airmotiv XT1.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Both Airmotiv XT1 and C 95 II features dual binding post speaker terminals for bi-amping or bi-wiring.
Emotiva Airmotiv XT1's Binding post terminals allows Bi-amping or bi-wiring
Jamo C 95 II's Posts terminals allows Bi-amping or bi-wiring
Cabinet Type and Port Position
Both Airmotiv XT1 and C 95 II have rear firing ports. Rear ported speakers generally need more room between the backside of the speaker and the wall compared to sealed and front/bottom ported speakers. Placing the speakers too close to the walls may cause the bass to sound boomy.
If you are limited in space and can't get the speakers away from the backwall, check our Speakers with Front Firing Ports page.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare Emotiva Airmotiv XT1's and Jamo C 95 II's external dimensions. Emotiva Airmotiv XT1 has external dimensions of 106 x 178 x 254 mm ( 41.75” x 7” x 10”) whereas Jamo C 95 II has external dimensions of 982.0 x 247.0 x 383.0mm ( 38-5/8 x 9-11/16 x 15-1/16inch) .
Emotiva Airmotiv XT1 is 25mm narrower and 129mm less deeper than Jamo C 95 II but it is also 78mm taller.
Below you can see the front view size comparison of Emotiva Airmotiv XT1 and Jamo C 95 II in scale.
Comparison image of Emotiva Airmotiv XT1 and Jamo C 95 II Size and External Dimensions
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the Emotiva Airmotiv XT1 is approximately 452.1cm2 / 70.1inch2 and base area of the Jamo C 95 II is approximately 946.0cm2 / 146.6inch2. The Airmotiv XT1 requires 52% less surface area than the C 95 II which gives it a small advantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The Emotiva Airmotiv XT1 weighs 15.90kg / 35lbs and the Jamo C 95 II weighs 19.91kg / 43.8lbs. This makes the C 95 II 25% heavier than the Airmotiv XT1.
Here is a comparison of how Airmotiv XT1 and C 95 II's weights compare with the average, max and min weights in Passive Floor-standing class.
Weight
All Floor-standing Speakers
What's in the Box of Jamo C 95 II?
Here are the items that come with the C 95 II:
Floorstanding loudspeakerGrille4 Outrigger feet4 Spikes (pre-installed on outrigger feet)4 Rubber feet8 Machine screws2 Jumper-straps (pre-installed)Hex-keyUser ManualImportant Safety InstructionsWarranty Information
 Max Input Power |
200 watts
vs
165 watts
|
Handle more power from your amplifier |
 Driver Setup |
3-way
vs
2-way
|
Have a dedicated mid-range driver |
 Number of Woofers |
3
vs
2
|
More woofers |
 High Frequency Response |
27k Hz
vs
24k Hz
|
Generates higher frequency |
 Base Surface Area |
452cm2 (222x254mm)
vs
946cm2 (247x383mm)
|
Takes less floor space |
 Nominal Impedance |
6 ohms
vs
4 ohms
|
Less selective with amplifiers |
| Woofer Size |
6 inches
vs
5.25 inches
|
Larger woofer |
| Low Frequency Response |
37 Hz
vs
45 Hz
|
Generates deeper bass |
 Height |
982mm
vs
1060mm
|
Easier to fit in smaller spaces |
 Price per pair* |
918USD
vs
999USD
|
costs less (*prices may change depending on the seller, location and time) |
| General |
Emotiva Airmotiv XT1 |
Jamo Concert 9 Series C 95 II |
| Brand |
Emotiva |
Jamo |
| Speaker Type |
Floor-standing speaker |
Floor-standing speaker |
| Power Range |
Up to 200 watts |
50-165 watts |
| Sensitivity |
89 dB |
89 dB |
| Impedance |
4 ohms |
6 ohms |
| Frequency Response |
45 Hz – 27 kHz |
37-24k Hz |
Drivers |
|
|
| Woofer Quantity |
3 |
2 |
| Woofer Size |
5.25" |
6" |
| Woofer Composition |
woven fiber cone |
Composite |
| Woofer Surround Material |
SBR |
Rubber |
| Tweeter Size |
25×32 mm" |
1" |
| Tweeter Type |
folded ribbon |
n/a |
| Aimable Tweeter |
No |
No |
| Midrange Driver |
4.5" |
No |
| Crossover Frequency |
410 Hz, 3.1 kHz |
n/a |
| Firing Direction |
rear |
rear |
Physical Specs |
|
|
| Height |
1060.0mm (41.7") |
982.0mm (38.7") |
| Width |
222.0mm (8.7") |
247.0mm (9.7") |
| Depth |
254.0mm (10") |
383.0mm (15.1") |
| Weight |
15.90kg (35lbs) |
19.91kg (43.8lbs) |
| Enclosure |
Bass reflex |
Bass Reflex |
| Finish |
n/a |
MDF/Wood-grain vinyl |
| Available Colors |
Black |
Black |
| Grille |
Yes |
Yes |
| Moisture Resistancy |
No |
No |
Connections |
|
|
| Biamp Inputs |
Yes |
Yes |
Other |
|
|
| Parts Warranty |
5 Years |
5 Years |
| Labor Warranty |
5 Years |
5 Years |