In this review, we will be comparing Airmotiv T2+ and Prime Tower, two Passive Floor-standing speakers from Emotiva and SVS. Let's have a brief look at the main features
of Emotiva Airmotiv T2+ and SVS Prime Tower first before getting into our more
detailed comparison.
What size room are the Emotiva Airmotiv T2+ and SVS Prime Tower speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the Emotiva Airmotiv T2+ and SVS Prime Tower compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
Both Airmotiv T2+ and Prime Tower are 3-way speakers.
| Driver |
Emotiva Airmotiv T2+ |
SVS Prime Tower |
|
Driver Setup
|
3-way
|
3-way
|
|
Tweeter
|
25×32 mm-inch
|
1-inch
|
|
Midrange
|
1 x 5.25-inch |
1 x 4.5-inch |
|
Woofer
|
2 x 8-inch
|
2 x 6.5-inch
|
Airmotiv T2+ features a 25×32 mm" folded ribbon Tweeter , a 5.25" Midrange and 2 x 8" woven fiber cone Woofer with a Crossover frequency at 350 Hz and 3200Hz. On the other hand, the Prime Tower features a 1" aluminum dome Tweeter , a 4.5" Midrange and 2 x 6.5" Polypropylene Woofer with a Crossover frequency at 350Hz and 2100Hz.
Frequency Response
Airmotiv T2+ has a frequency range of 35 Hz – 28 kHz whereas Prime Tower has a frequency range of 30-25k Hz. With a minimum frequency of 30Hz, the Prime Tower can go significantly deeper on the low side and provide stronger bass compared to the Airmotiv T2+'s min frequency of 35Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Floor-standing class in our database.
Low Frequency
Floor-standing Speakers
High Frequency
Floor-standing Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Airmotiv T2+ is a 4 ohms speaker compared to the Prime Tower which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Airmotiv T2+ can provide this impedance level.
These two speakers also have different sensitivity levels. Airmotiv T2+ sensitivity is rated at 91 dB and the Prime Tower's is rated at 87 dB. This 4 dB difference makes the Emotiva Airmotiv T2+ a more sensitive speaker compared to SVS Prime Tower, hence will play louder with the same amount of watts.
Sensitivity
Floor-standing Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Airmotiv T2+ can handle a max power of 250 watts RMS from the amp the whereas Airmotiv T2+ has a max power handling value of 200 watts RMS , 50 watts less than the Prime Tower.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Airmotiv T2+ features Binding post posts which make bi-amping or bi-wiring possible. Prime Tower has a 5-Way post which doesn't feature bi-amping/bi-wiring.
Emotiva Airmotiv T2+'s Binding post terminals allows Bi-amping or bi-wiring
SVS Prime Tower's 5-Way post terminals
Cabinet Type and Port Position
Both Airmotiv T2+ and Prime Tower have rear firing ports. Rear ported speakers generally need more room between the backside of the speaker and the wall compared to sealed and front/bottom ported speakers. Placing the speakers too close to the walls may cause the bass to sound boomy.
If you are limited in space and can't get the speakers away from the backwall, check our Speakers with Front Firing Ports page.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare Emotiva Airmotiv T2+'s and SVS Prime Tower's external dimensions. Emotiva Airmotiv T2+ has external dimensions of 1085.0 x 310.0 x 439.0mm ( 42-11/16 x 12-3/16 x 17-1/4inch) whereas SVS Prime Tower has external dimensions of 931.0 x 204.0 x 297.0mm ( 36-5/8 x 8 x 11-11/16inch) .
Emotiva Airmotiv T2+ is clearly the larger of the two speakers. Its body is 106mm wider, 154mm taller and 142mm deeper than SVS Prime Tower.
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the Emotiva Airmotiv T2+ is approximately 1360.9cm2 / 210.9inch2 and base area of the SVS Prime Tower is approximately 605.9cm2 / 93.9inch2. The Airmotiv T2+ requires 125% more surface area than the Prime Tower which gives it a small disadvantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The Emotiva Airmotiv T2+ weighs 25.90kg / 57lbs and the SVS Prime Tower weighs 18.23kg / 40.1lbs. This makes the Airmotiv T2+ 42% heavier than the Prime Tower.
Here is a comparison of how Airmotiv T2+ and Prime Tower's weights compare with the average, max and min weights in Passive Floor-standing class.
Weight
All Floor-standing Speakers
What's in the Box of SVS Prime Tower?
Here are the items that come with the Prime Tower:
Floorstanding loudspeakerGrille (pre-installed)4 Elastomer isolation feet (pre-installed)4 Spike feet4 Nuts4 Protective discsOwners ManualSVS brochureOnline Product Registration Card
 Sensitivity |
91 dB
vs
87 dB
|
Play louder with same amount of amplification power |
 Woofer Size |
8 inches
vs
6.5 inches
|
Larger woofer |
 High Frequency Response |
28k Hz
vs
25k Hz
|
Generates higher frequency |
 Bi-Amping and Bi-Wiring |
Yes
vs
No
|
Allows bi-amping and bi-wiring connections |
 Price per pair* |
1099USD
vs
1400USD
|
costs less (*prices may change depending on the seller, location and time) |
 Max Input Power |
250 watts
vs
200 watts
|
Handle more power from your amplifier |
 Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
| Low Frequency Response |
30 Hz
vs
35 Hz
|
Generates deeper bass |
 Height |
931mm
vs
1085mm
|
Easier to fit in smaller spaces |
 Base Surface Area |
605cm2 (204x297mm)
vs
1360cm2 (310x439mm)
|
Takes less floor space |
| General |
Emotiva Airmotiv T2+ |
SVS Prime Tower |
| Brand |
Emotiva |
SVS |
| Speaker Type |
Floor-standing speaker |
Floor-standing speaker |
| Power Range |
Up to 200 watts |
20-250 watts |
| Sensitivity |
91 dB |
87 dB |
| Impedance |
4 ohms |
8 ohms |
| Frequency Response |
35 Hz – 28 kHz |
30-25k Hz |
Drivers |
|
|
| Woofer Quantity |
2 |
2 |
| Woofer Size |
8" |
6.5" |
| Woofer Composition |
woven fiber cone |
Polypropylene |
| Woofer Surround Material |
n/a |
Rubber |
| Tweeter Size |
25×32 mm" |
1" |
| Tweeter Type |
folded ribbon |
dome |
| Aimable Tweeter |
No |
No |
| Midrange Driver |
5.25" |
4.5" |
| Crossover Frequency |
350 Hz and 3200Hz |
350Hz and 2100Hz |
| Firing Direction |
rear |
rear |
Physical Specs |
|
|
| Height |
1085.0mm (42.7") |
931.0mm (36.7") |
| Width |
310.0mm (12.2") |
204.0mm (8") |
| Depth |
439.0mm (17.3") |
297.0mm (11.7") |
| Weight |
25.90kg (57lbs) |
18.23kg (40.1lbs) |
| Enclosure |
Bass reflex |
Bass Reflex |
| Finish |
HDF |
MDF/Wood-grain vinyl |
| Available Colors |
Black |
Black |
| Grille |
Yes |
Yes |
| Moisture Resistancy |
No |
No |
Connections |
|
|
| Biamp Inputs |
Yes |
No |
Other |
|
|
| Parts Warranty |
5 Years |
5 Years |
| Labor Warranty |
5 Years |
5 Years |