In this review, we will be comparing Airmotiv B2+ and Prime Bookshelf, two Passive Bookshelf speakers from Emotiva and SVS. Let's have a brief look at the main features
of Emotiva Airmotiv B2+ and SVS Prime Bookshelf first before getting into our more
detailed comparison.
What size room are the Emotiva Airmotiv B2+ and SVS Prime Bookshelf speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the Emotiva Airmotiv B2+ and SVS Prime Bookshelf compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
Both Airmotiv B2+ and Prime Bookshelf are 2-way speakers.
| Driver |
Emotiva Airmotiv B2+ |
SVS Prime Bookshelf |
|
Driver Setup
|
2-way
|
2-way
|
|
Tweeter
|
25×32 mm-inch
|
1-inch
|
|
Midrange
|
- |
- |
|
Woofer
|
1 x 6.25-inch
|
1 x 6.5-inch
|
Airmotiv B2+ features a 25×32 mm" folded ribbon Tweeter and 1 x 6.25" woven fiber cone Woofer with a Crossover frequency at 2000Hz. On the other hand, the Prime Bookshelf features a 1" aluminum Hard-Dome Tweeter and 1 x 6.5" Woofer with a Crossover frequency at 2300Hz.
Frequency Response
Airmotiv B2+ has a frequency range of 40-28k Hz whereas Prime Bookshelf has a frequency range of 48-25k Hz. With a minimum frequency of 40Hz, the Airmotiv B2+ can go significantly deeper on the low side and provide stronger bass compared to the Prime Bookshelf's min frequency of 48Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Bookshelf class in our database.
Low Frequency
Bookshelf Speakers
High Frequency
Bookshelf Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Airmotiv B2+ is a 4 ohms speaker compared to the Prime Bookshelf which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Airmotiv B2+ can provide this impedance level.
These two speakers also have different sensitivity levels. Airmotiv B2+ sensitivity is rated at 86 dB and the Prime Bookshelf's is rated at 87 dB. This 1 dB difference makes the SVS Prime Bookshelf a more sensitive speaker compared to Emotiva Airmotiv B2+, hence will play louder with the same amount of watts.
Sensitivity
Bookshelf Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Airmotiv B2+ can handle a max power of 150 watts RMS from the amp the whereas Airmotiv B2+ has a max power handling value of 125 watts RMS , 25 watts less than the Prime Bookshelf.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Airmotiv B2+ features Binding post posts which make bi-amping or bi-wiring possible. Prime Bookshelf has a 5-way post which doesn't feature bi-amping/bi-wiring.
Emotiva Airmotiv B2+'s Binding post terminals allows Bi-amping or bi-wiring
SVS Prime Bookshelf's 5-way post terminals
Cabinet Type and Port Position
Both Airmotiv B2+ and Prime Bookshelf have rear firing ports. Rear ported speakers generally need more room between the backside of the speaker and the wall compared to sealed and front/bottom ported speakers. Placing the speakers too close to the walls may cause the bass to sound boomy.
If you are limited in space and can't get the speakers away from the backwall, check our Speakers with Front Firing Ports page.
Emotiva Airmotiv B2+ Port
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare Emotiva Airmotiv B2+'s and SVS Prime Bookshelf's external dimensions. Emotiva Airmotiv B2+ has external dimensions of 324.0 x 216.0 x 293.0mm ( 12-3/4-inch x 8-1/2-inch x 11-1/2-inch) whereas SVS Prime Bookshelf has external dimensions of 337.8 x 203.2 x 261.6mm ( 13.2 x 8.0 x 10.2inch) .
SVS Prime Bookshelf is 12.8mm narrower and 31.4mm less deeper than Emotiva Airmotiv B2+ but it is also 13.8mm taller.
Below you can see the front view size comparison of Emotiva Airmotiv B2+ and SVS Prime Bookshelf in scale.
Comparison image of Emotiva Airmotiv B2+ and SVS Prime Bookshelf Size and External Dimensions
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the Emotiva Airmotiv B2+ is approximately 632.9cm2 / 98.1inch2 and base area of the SVS Prime Bookshelf is approximately 531.6cm2 / 82.4inch2. The Airmotiv B2+ requires 19% more surface area than the Prime Bookshelf which gives it a small disadvantage on placement in tight spaces.
Here is an another comparison that shows both speakers on a BDI Octave Media Cabinet, next to a standard size amplifier and turntable in scale:
Size Comparison image of Emotiva Airmotiv B2+ and SVS Prime Bookshelf on a Media Console
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The Emotiva Airmotiv B2+ weighs 7.10kg / 15.6lbs and the SVS Prime Bookshelf weighs 7.03kg / 15.5lbs. This makes the Airmotiv B2+ 1% heavier than the Prime Bookshelf.
Here is a comparison of how Airmotiv B2+ and Prime Bookshelf's weights compare with the average, max and min weights in Passive Bookshelf class.
Weight
All Bookshelf Speakers
What's in the Box of SVS Prime Bookshelf?
Here are the items that come with the Prime Bookshelf:
2 Bookshelf loudspeakers 2 Grilles (pre-installed) 8 Self-adhesive rubber bumpers Owners Manual SVS brochure Online Product Registration Card
 Low Frequency Response |
40 Hz
vs
48 Hz
|
Generates deeper bass |
 High Frequency Response |
28k Hz
vs
25k Hz
|
Generates higher frequency |
 Bi-Amping and Bi-Wiring |
Yes
vs
No
|
Allows bi-amping and bi-wiring connections |
 Height |
324mm
vs
337mm
|
Easier to fit in smaller spaces |
 Price per pair* |
499USD
vs
600USD
|
costs less (*prices may change depending on the seller, location and time) |
 Max Input Power |
150 watts
vs
125 watts
|
Handle more power from your amplifier |
 Sensitivity |
87 dB
vs
86 dB
|
Play louder with same amount of amplification power |
 Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
| Woofer Size |
6.5 inches
vs
6.25 inches
|
Larger woofer |
 Base Surface Area |
531cm2 (203x261mm)
vs
632cm2 (216x293mm)
|
Takes less floor space |
| General |
Emotiva Airmotiv B2+ |
SVS Prime Bookshelf |
| Brand |
Emotiva |
SVS |
| Speaker Type |
Bookshelf speakers |
Bookshelf speakers |
| Power Range |
Up to 125 watts |
25-150 watts |
| Sensitivity |
86 dB |
87 dB |
| Impedance |
4 ohms |
8 ohms |
| Frequency Response |
40-28k Hz |
48-25k Hz |
Drivers |
|
|
| Woofer Quantity |
1 |
1 |
| Woofer Size |
6.25" |
6.5" |
| Woofer Composition |
woven fiber cone |
|
| Woofer Surround Material |
SBR |
Polypropylene |
| Tweeter Size |
25×32 mm" |
1" |
| Tweeter Type |
folded ribbon |
Hard-Dome |
| Aimable Tweeter |
No |
No |
| Midrange Driver |
No |
No |
| Crossover Frequency |
2000Hz |
2300Hz |
| Firing Direction |
rear |
rear |
Physical Specs |
|
|
| Height |
324.0mm (12.8") |
337.8mm (13.3") |
| Width |
216.0mm (8.5") |
203.2mm (8") |
| Depth |
293.0mm (11.5") |
261.6mm (10.3") |
| Weight |
7.10kg (15.6lbs) |
7.03kg (15.5lbs) |
| Enclosure |
Bass reflex |
Bass Reflex |
| Finish |
HDF |
MDF/Wood-grain vinyl |
| Available Colors |
Black |
Black Ash,Piano Gloss Black |
| Mounting Bracket |
No |
No |
| Recommended Stand Height |
n/a |
24-28" |
| Grille |
Yes |
Yes |
| Moisture Resistancy |
No |
No |
Connections |
|
|
| Biamp Inputs |
Yes |
No |
Other |
|
|
| Parts Warranty |
5 Years |
5 Years |
| Labor Warranty |
5 Years |
5 Years |