In this review, we will be comparing Airmotiv C2+ and Blackstone TL1, two Passive Center Channel speakers from Emotiva and Polk Audio. Let's have a brief look at the main features
of Emotiva Airmotiv C2+ and Polk TL1 first before getting into our more
detailed comparison.
What size room are the Emotiva Airmotiv C2+ and Polk TL1 speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the Emotiva Airmotiv C2+ and Polk TL1 compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
One of the fundamental differences between these two speakers is that Airmotiv C2+ is a 3-way design whereas the Blackstone TL1 is a 2-way speaker. 3-way designs utilize a midrange driver in addition to the tweeter and woofer on 2-way designs. Designing a crossover for a 3-way speaker is a complicated process and generally increases the overall cost of the speaker.
| Driver |
Emotiva Airmotiv C2+ |
Polk TL1 |
|
Driver Setup
|
3-way
|
2-way
|
|
Tweeter
|
25×32 mm-inch
|
0.5-inch
|
|
Midrange
|
2 x 3-inch |
- |
|
Woofer
|
2 x 6.5-inch
|
2 x 2.5-inch
|
Airmotiv C2+ features a 25×32 mm" folded ribbon Tweeter , a 3" Midrange and 2 x 6.5" woven fiber cone Woofer with a Crossover frequency at 350 Hz and 3200Hz. On the other hand, the Blackstone TL1 features a 0.5" silk dome Tweeter and 2 x 2.5" Dynamic Balance Woofer .
Frequency Response
Airmotiv C2+ has a frequency range of 45 Hz – 28 kHz whereas Blackstone TL1 has a frequency range of 125-20k Hz. With a minimum frequency of 45Hz, the Airmotiv C2+ can go significantly deeper on the low side and provide stronger bass compared to the Blackstone TL1's min frequency of 125Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Center Channel class in our database.
Low Frequency
Center Channel Speakers
High Frequency
Center Channel Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Airmotiv C2+ is a 4 ohms speaker compared to the Blackstone TL1 which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Airmotiv C2+ can provide this impedance level.
These two speakers also have different sensitivity levels. Airmotiv C2+ sensitivity is rated at 92 dB and the Blackstone TL1's is rated at 89 dB. This 3 dB difference makes the Emotiva Airmotiv C2+ a more sensitive speaker compared to Polk TL1, hence will play louder with the same amount of watts.
Sensitivity
Center Channel Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Airmotiv C2+ can handle a max power of 150 watts RMS from the amp the whereas Blackstone TL1 has a max power handling value of 125 watts RMS, 25 watts less than the Airmotiv C2+.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Airmotiv C2+ features Binding post posts which make bi-amping or bi-wiring possible. Blackstone TL1 has a 5-Way post which doesn't feature bi-amping/bi-wiring.
Emotiva Airmotiv C2+'s Binding post terminals allows Bi-amping or bi-wiring
Cabinet Type and Port Position
Both Airmotiv C2+ and Blackstone TL1 have rear firing ports. Rear ported speakers generally need more room between the backside of the speaker and the wall compared to sealed and front/bottom ported speakers. Placing the speakers too close to the walls may cause the bass to sound boomy.
If you are limited in space and can't get the speakers away from the backwall, check our Speakers with Front Firing Ports page.
Emotiva Airmotiv C2+ Port
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare Emotiva Airmotiv C2+'s and Polk TL1's external dimensions. Emotiva Airmotiv C2+ has external dimensions of 220.0 x 812.0 x 267.0mm ( 8-5/8 x 31-15/16 x 10-1/2inch) whereas Polk TL1 has external dimensions of 101.0 x 381.0 x 88.0mm ( 3-15/16 x 15 x 3-7/16inch) .
Emotiva Airmotiv C2+ is clearly the larger of the two speakers. Its body is 431mm wider, 119mm taller and 179mm deeper than Polk TL1.
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the Emotiva Airmotiv C2+ is approximately 2168.0cm2 / 336.0inch2 and base area of the Polk TL1 is approximately 335.3cm2 / 52.0inch2. The Airmotiv C2+ requires 547% more surface area than the Blackstone TL1 which gives it a small disadvantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The Emotiva Airmotiv C2+ weighs 16.40kg / 36.1lbs and the Polk TL1 weighs 1.84kg / 4lbs. This makes the Airmotiv C2+ 791% heavier than the Blackstone TL1.
Here is a comparison of how Airmotiv C2+ and Blackstone TL1's weights compare with the average, max and min weights in Passive Center Channel class.
Weight
All Center Channel Speakers
What's in the Box of Polk TL1?
Here are the items that come with the Blackstone TL1:
Gloss-black center-channel loudspeakerDetachable black cloth grille (attached)System Diagram/Warranty sheetTemplateOnline Product Registration cardImportant Safety Instructions
 Max Input Power |
150 watts
vs
125 watts
|
Handle more power from your amplifier |
 Driver Setup |
3-way
vs
2-way
|
Have a dedicated mid-range driver |
 Sensitivity |
92 dB
vs
89 dB
|
Play louder with same amount of amplification power |
 Woofer Size |
6.5 inches
vs
2.5 inches
|
Larger woofer |
| Low Frequency Response |
45 Hz
vs
125 Hz
|
Generates deeper bass |
 High Frequency Response |
28k Hz
vs
20k Hz
|
Generates higher frequency |
 Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
 Height |
101mm
vs
220mm
|
Easier to fit in smaller spaces |
 Base Surface Area |
335cm2 (381x88mm)
vs
2168cm2 (812x267mm)
|
Takes less floor space |
 Price per pair* |
79USD
vs
499USD
|
costs less (*prices may change depending on the seller, location and time) |
| General |
Emotiva Airmotiv C2+ |
Polk Audio Blackstone TL1 |
| Brand |
Emotiva |
Polk Audio |
| Speaker Type |
Center channel speaker |
Center channel speaker |
| Power Range |
Up to 150 watts |
10-125 watts |
| Sensitivity |
92 dB |
89 dB |
| Impedance |
4 ohms |
8 ohms |
| Frequency Response |
45 Hz – 28 kHz |
125-20k Hz |
Drivers |
|
|
| Woofer Quantity |
2 |
2 |
| Woofer Size |
6.5" |
2.5" |
| Woofer Composition |
woven fiber cone |
Dynamic Balance |
| Tweeter Size |
25×32 mm" |
0.5" |
| Tweeter Type |
folded ribbon |
dome |
| Aimable Tweeter |
No |
No |
| Midrange Driver |
3" |
No |
| Crossover Frequency |
350 Hz and 3200Hz |
n/a |
| Firing Direction |
rear |
rear |
Physical Specs |
|
|
| Height |
220.0mm (8.7") |
101.0mm (4") |
| Width |
812.0mm (32") |
381.0mm (15") |
| Depth |
267.0mm (10.5") |
88.0mm (3.5") |
| Weight |
16.40kg (36.1lbs) |
1.84kg (4lbs) |
| Enclosure |
Bass reflex |
Bass Reflex |
| Finish |
HDF |
n/a |
| Available Colors |
Black |
Gloss Black |
| Grille |
Yes |
Yes |
| Moisture Resistancy |
No |
No |
Connections |
|
|
| Biamp Inputs |
Yes |
n/a |
Other |
|
|
| Parts Warranty |
5 Years |
5 Years |
| Labor Warranty |
5 Years |
5 Years |