No single best amplifier here. What decides it is what you have to drive, what you need to plug in, and how much of the system you want in one box.
| Area | Better | Why |
|---|
| Power | evenly matched | Effectively the same output - 80W against 70W into 8 ohms is under 1dB, which is not an audible difference in loudness. |
| Grip on hard loads | B | Audiolab 7000A holds up better into a 4-ohm load: its output increases strongly to 110W, where the other barely increases. That matters with demanding speakers far more than the 8-ohm figure does. |
| Noise floor | B | Audiolab 7000A is the quieter design on paper - 110dB against 95dB. Audible mainly with sensitive speakers in a quiet room. |
| Built-in DAC | A | Both decode on board. NAD C 379 goes higher - 384kHz against 192kHz. Very few recordings exist above 192kHz, so treat this as headroom, not as sound quality. |
| Room to grow | B | Only Audiolab 7000A offers a pre-out/main-in loop - which decides whether you can add a subwoofer or a power amplifier later without replacing the box. |
| Amplifier class | depends | NAD C 379 is Class D and Audiolab 7000A is Class A/B. Class D runs cool and draws almost nothing at idle; Class A/B runs warm and is the long-established mainstream choice. Modern examples of both measure well - judge by the rest of the page. |
| Shelf space | depends | Audiolab 7000A takes up about 17% less shelf area (1510cm² against 1810cm²), and it is 76mm shallower, which is the measurement that decides whether a rack door shuts. |
| Price | B | Audiolab 7000A costs less - $999 against $1,099 at list. |
A NAD C 379 B Audiolab 7000A
depends neither is better in the abstract - it turns on your room, your system or how you will use them. Only specs published for both amplifiers are judged; anything missing on either side is left out rather than guessed.
Which should you choose?
Audiolab 7000A has the edge on paper, though not by much. The rows marked "depends" are more likely to decide this than the score is. If your speakers are a difficult load - 4 ohms nominal, big woofers, or a sensitivity in the low 80s - Audiolab 7000A is the safer partner, because how an amplifier behaves when the impedance drops matters more than its 8-ohm rating.
What a spec sheet cannot show: how either sounds with your speakers, how the controls feel day to day, and what the app is like to live with - which is where most all-in-one amplifiers are actually won or lost. Power figures are the manufacturers' own and are not measured to a common standard, so treat small differences as noise. If you can hear both, that will tell you more than any row above.