In this review, we will be comparing Motion XT F200 and F328Be, two Passive Floor-standing speakers from MartinLogan and Revel. Let's have a brief look at the main features
of MartinLogan Motion XT F200 and Revel PerformaBe F328Be first before getting into our more
detailed comparison.
What size room are the MartinLogan Motion XT F200 and Revel PerformaBe F328Be speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the MartinLogan Motion XT F200 and Revel PerformaBe F328Be compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
Both Motion XT F200 and F328Be are 3-way speakers.
| Driver |
MartinLogan Motion XT F200 |
Revel PerformaBe F328Be |
|
Driver Setup
|
3-way
|
3-way
|
|
Tweeter
|
1.25 x 2.4-inch
|
1-inch
|
|
Midrange
|
1 x 6.5-inch |
1 x 5.25-inch |
|
Woofer
|
3 x 8-inch
|
3 x 8.0-inch
|
Motion XT F200 features a 1.25 x 2.4" Folded Motion XT Tweeter , a 6.5" Midrange and 3 x 8" Aluminum Woofer with a Crossover frequency at 300Hz and 2600Hz. On the other hand, the F328Be features a 1" Tweeter , a 5.25" Midrange and 3 x 8.0" Aluminum Woofer .
Frequency Response
Motion XT F200 has a frequency range of 27-25k Hz whereas F328Be has a frequency range of 26-40k Hz. With a minimum frequency of 26Hz, the F328Be can go slightly deeper then the Motion XT F200's min frequency of 27Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Floor-standing class in our database.
Low Frequency
Floor-standing Speakers
High Frequency
Floor-standing Speakers
MartinLogan Motion XT F200
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Motion XT F200 is a 4 ohms speaker compared to the F328Be which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Motion XT F200 can provide this impedance level.
These two speakers also have different sensitivity levels. Motion XT F200 sensitivity is rated at 92 dB and the F328Be's is rated at 91 dB. This 1 dB difference makes the MartinLogan Motion XT F200 a more sensitive speaker compared to Revel PerformaBe F328Be, hence will play louder with the same amount of watts.
Sensitivity
Floor-standing Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Motion XT F200 can handle a max power of 600 watts RMS from the amp the whereas F328Be has a max power handling value of 300 watts RMS, 300 watts less than the Motion XT F200.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Both Motion XT F200 and F328Be features dual binding post speaker terminals for bi-amping or bi-wiring.
MartinLogan Motion XT F200's Custom 5-way bi-wire tool-less binding posts terminals allows Bi-amping or bi-wiring
Cabinet Type and Port Position
Motion XT F200 has a bottom firing port whereas F328Be has a rear firing ports. MartinLogan Motion XT F200's bottom-firing port gives more flexibility in placement in regards to proximity to walls compared to Revel PerformaBe F328Be with its rear-firing port.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare MartinLogan Motion XT F200's and Revel PerformaBe F328Be's external dimensions. MartinLogan Motion XT F200 has external dimensions of 1289 x 349 x 419mm ( 50-3/4inch x 13-3/4inch x 16-1/2inch ) whereas Revel PerformaBe F328Be has external dimensions of 1294.0 x 343.0 x 448.0mm ( 50-15/16 x 13-1/2 x 17-5/8inch) .
MartinLogan Motion XT F200 is 5mm shorter and 29mm less deeper than Revel PerformaBe F328Be but it is also 6mm wider.
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the MartinLogan Motion XT F200 is approximately 1462.3cm2 / 226.7inch2 and base area of the Revel PerformaBe F328Be is approximately 1536.6cm2 / 238.2inch2. The Motion XT F200 requires 5% less surface area than the F328Be which gives it a small advantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The MartinLogan Motion XT F200 weighs 39.00kg / 85.8lbs and the Revel PerformaBe F328Be weighs 51.18kg / 112.6lbs. This makes the F328Be 31% heavier than the Motion XT F200.
Here is a comparison of how Motion XT F200 and F328Be's weights compare with the average, max and min weights in Passive Floor-standing class.
Weight
All Floor-standing Speakers
MartinLogan Motion XT F200
What's in the Box of Revel PerformaBe F328Be?
Here are the items that come with the F328Be:
Floorstanding loudspeakerGrille4 Spike feet4 Locking rings4 Washers2 Terminal jumpers (pre-installed)2 Foam port plugsOwners Manual
 Max Input Power |
600 watts
vs
300 watts
|
Handle more power from your amplifier |
 Sensitivity |
92 dB
vs
91 dB
|
Play louder with same amount of amplification power |
 Height |
1289mm
vs
1294mm
|
Easier to fit in smaller spaces |
 Base Surface Area |
1462cm2 (349x419mm)
vs
1536cm2 (343x448mm)
|
Takes less floor space |
 Price per pair* |
5498USD
vs
17600USD
|
costs less (*prices may change depending on the seller, location and time) |
 Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
 Low Frequency Response |
26 Hz
vs
27 Hz
|
Generates deeper bass |
 High Frequency Response |
40k Hz
vs
25k Hz
|
Generates higher frequency |
| General |
MartinLogan Motion® XT F200 |
Revel PerformaBe F328Be |
| Brand |
MartinLogan |
Revel |
| Speaker Type |
Floor-standing speaker |
Floor-standing speaker |
| Power Range |
20-600 watts |
50-300 watts |
| Sensitivity |
92 dB |
91 dB |
| Impedance |
4 ohms |
8 ohms |
| Frequency Response |
27-25k Hz |
26-40k Hz |
Drivers |
|
|
| Woofer Quantity |
3 |
3 |
| Woofer Size |
8" |
8.0" |
| Woofer Composition |
Aluminum |
Aluminum |
| Woofer Surround Material |
Rubber |
--- |
| Tweeter Size |
1.25 x 2.4" |
1" |
| Tweeter Type |
Folded Motion XT |
n/a |
| Aimable Tweeter |
No |
No |
| Midrange Driver |
6.5" |
5.25" |
| Crossover Frequency |
300Hz and 2600Hz |
n/a |
| Firing Direction |
bottom |
rear |
| Suggested Break-in Period |
Allow 72 hours of break-in |
n/a |
Physical Specs |
|
|
| Height |
1289.0mm (50.7") |
1294.0mm (50.9") |
| Width |
349.0mm (13.7") |
343.0mm (13.5") |
| Depth |
419.0mm (16.5") |
448.0mm (17.6") |
| Weight |
39.00kg (85.8lbs) |
51.18kg (112.6lbs) |
| Enclosure |
Bass Reflex |
Bass Reflex |
| Finish |
MDF/Wood veneer |
--- |
| Available Colors |
Gloss Black, Walnut, and Satin White |
Gloss Black |
| Grille |
Yes |
Yes |
| Moisture Resistancy |
No |
No |
Connections |
|
|
| Biamp Inputs |
Yes |
Yes |
Other |
|
|
| Parts Warranty |
5 Years |
5 Years |
| Labor Warranty |
5 Years |
5 Years |