In this review, we will be comparing HDI-3600 and S55, two Passive Floor-standing speakers from JBL and Polk Audio. Let's have a brief look at the main features
of JBL HDI-3600 and Polk S55 first before getting into our more
detailed comparison.
What size room are the JBL HDI-3600 and Polk S55 speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the JBL HDI-3600 and Polk S55 compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
Both HDI-3600 and S55 are 2-way speakers.
Driver |
JBL HDI-3600 |
Polk S55 |
Driver Setup
|
2-way
|
2-way
|
Tweeter
|
1-inch
|
1-inch
|
Midrange
|
- |
- |
Woofer
|
3 x 6.5-inch
|
2 x 6.5-inch
|
HDI-3600 features a 1" Tweeter and 3 x 6.5" Aluminum Woofer . On the other hand, the S55 features a 1" Terylene Dome Tweeter and 2 x 6.5" Mica-reinforced polypropylene Woofer with a Crossover frequency at 2500Hz.
Frequency Response
HDI-3600 has a frequency range of 38-30k Hz whereas S55 has a frequency range of 32-40k Hz. With a minimum frequency of 32Hz, the S55 can go significantly deeper on the low side and provide stronger bass compared to the HDI-3600's min frequency of 38Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Floor-standing class in our database.
Low Frequency
Floor-standing Speakers
High Frequency
Floor-standing Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
HDI-3600 is a 4 ohms speaker compared to the S55 which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the HDI-3600 can provide this impedance level.
On the other hand, they have the same sensitivity of 90 dBdB.
Sensitivity
Floor-standing Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
HDI-3600 can handle a max power of 250 watts RMS from the amp the whereas S55 has a max power handling value of 200 watts RMS, 50 watts less than the HDI-3600.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Both HDI-3600 and S55 features dual binding post speaker terminals for bi-amping or bi-wiring.
Cabinet Type and Port Position
HDI-3600 has a rear firing port whereas S55 has a bottom firing ports. Polk S55's bottom-firing port gives more flexibility in placement in regards to proximity to walls compared to JBL HDI-3600 with its rear-firing port.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare JBL HDI-3600's and Polk S55's external dimensions. JBL HDI-3600 has external dimensions of 1028.0 x 259.0 x 345.0mm ( 40-7/16 x 10-3/16 x 13-9/16inch) whereas Polk S55 has external dimensions of 1056.0 x 299.0 x 315.0mm ( 41-9/16 x 11-3/4 x 12-3/8inch) .
JBL HDI-3600 is 40mm narrower and 28mm shorter than Polk S55 but it is also 30mm deeper.
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the JBL HDI-3600 is approximately 893.6cm2 / 138.5inch2 and base area of the Polk S55 is approximately 941.9cm2 / 146.0inch2. The HDI-3600 requires 5% less surface area than the S55 which gives it a small advantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The JBL HDI-3600 weighs 28.09kg / 61.8lbs and the Polk S55 weighs 20.00kg / 44lbs. This makes the HDI-3600 40% heavier than the S55.
Here is a comparison of how HDI-3600 and S55's weights compare with the average, max and min weights in Passive Floor-standing class.
Weight
All Floor-standing Speakers
What's in the Box of JBL HDI-3600?
Here are the items that are included inside the box of HDI-3600:
Floorstanding loudspeakerGrille2 Jumper-straps (pre-installed)4 Spike feetOwners Manual
What's in the Box of Polk S55?
Here are the items that come with the S55:
Floorstanding loudspeakerGrille (attached)4 Feet (pre-installed)Owners ManualOnline Product Registration
Max Input Power |
250 watts
vs
200 watts
|
Handle more power from your amplifier |
Number of Woofers |
3
vs
2
|
More woofers |
Height |
1028mm
vs
1056mm
|
Easier to fit in smaller spaces |
Base Surface Area |
893cm2 (259x345mm)
vs
941cm2 (299x315mm)
|
Takes less floor space |
Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
Low Frequency Response |
32 Hz
vs
38 Hz
|
Generates deeper bass |
High Frequency Response |
40k Hz
vs
30k Hz
|
Generates higher frequency |
Price per pair* |
658USD
vs
4180USD
|
costs less (*prices may change depending on the seller, location and time) |
General |
JBL HDI-3600 |
Polk Audio Signature S55 |
Brand |
JBL |
Polk Audio |
Speaker Type |
Floor-standing speaker |
Floor-standing speaker |
Power Range |
20-250 watts |
20-200 watts |
Sensitivity |
90 dB |
90 dB |
Impedance |
4 ohms |
8 ohms |
Frequency Response |
38-30k Hz |
32-40k Hz |
Drivers |
|
|
Woofer Quantity |
3 |
2 |
Woofer Size |
6.5" |
6.5" |
Woofer Composition |
Aluminum |
Mica-reinforced polypropylene |
Woofer Surround Material |
Rubber |
Butyl rubber |
Tweeter Size |
1" |
1" |
Tweeter Type |
n/a |
Dome |
Aimable Tweeter |
No |
No |
Midrange Driver |
No |
No |
Crossover Frequency |
n/a |
2500Hz |
Firing Direction |
rear |
bottom |
Physical Specs |
|
|
Height |
1028.0mm (40.5") |
1056.0mm (41.6") |
Width |
259.0mm (10.2") |
299.0mm (11.8") |
Depth |
345.0mm (13.6") |
315.0mm (12.4") |
Weight |
28.09kg (61.8lbs) |
20.00kg (44lbs) |
Enclosure |
Bass Reflex |
Bass Reflex |
Finish |
MDF/Wood-veneer |
Meddite MDF |
Available Colors |
Grey |
Black |
Grille |
Yes |
Yes |
Moisture Resistancy |
No |
No |
Connections |
|
|
Biamp Inputs |
Yes |
Yes |
Other |
|
|
Parts Warranty |
5 Years |
5 Years |
Labor Warranty |
5 Years |
5 Years |