In this review, we will be comparing Airmotiv T2+ and S60, two Passive Floor-standing speakers from Emotiva and Polk Audio. Let's have a brief look at the main features
of Emotiva Airmotiv T2+ and Polk S60 first before getting into our more
detailed comparison.
What size room are the Emotiva Airmotiv T2+ and Polk S60 speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the Emotiva Airmotiv T2+ and Polk S60 compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
One of the fundamental differences between these two speakers is that Airmotiv T2+ is a 3-way design whereas the S60 is a 2-way speaker. 3-way designs utilize a midrange driver in addition to the tweeter and woofer on 2-way designs. Designing a crossover for a 3-way speaker is a complicated process and generally increases the overall cost of the speaker.
Driver |
Emotiva Airmotiv T2+ |
Polk S60 |
Driver Setup
|
3-way
|
2-way
|
Tweeter
|
25×32 mm-inch
|
1-inch
|
Midrange
|
1 x 5.25-inch |
- |
Woofer
|
2 x 8-inch
|
3 x 6.5-inch
|
Airmotiv T2+ features a 25×32 mm" folded ribbon Tweeter , a 5.25" Midrange and 2 x 8" woven fiber cone Woofer with a Crossover frequency at 350 Hz and 3200Hz. On the other hand, the S60 features a 1" Terylene Dome Tweeter and 3 x 6.5" Mica-reinforced polypropylene Woofer with a Crossover frequency at 2500Hz.
Frequency Response
Airmotiv T2+ has a frequency range of 35 Hz – 28 kHz whereas S60 has a frequency range of 26-40k Hz. With a minimum frequency of 26Hz, the S60 can go significantly deeper on the low side and provide stronger bass compared to the Airmotiv T2+'s min frequency of 35Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Floor-standing class in our database.
Low Frequency
Floor-standing Speakers
High Frequency
Floor-standing Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Airmotiv T2+ is a 4 ohms speaker compared to the S60 which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Airmotiv T2+ can provide this impedance level.
These two speakers also have different sensitivity levels. Airmotiv T2+ sensitivity is rated at 91 dB and the S60's is rated at 90 dB. This 1 dB difference makes the Emotiva Airmotiv T2+ a more sensitive speaker compared to Polk S60, hence will play louder with the same amount of watts.
Sensitivity
Floor-standing Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Airmotiv T2+ can handle a max power of 300 watts RMS from the amp the whereas Airmotiv T2+ has a max power handling value of 200 watts RMS , 100 watts less than the S60.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Both Airmotiv T2+ and S60 features dual binding post speaker terminals for bi-amping or bi-wiring.
Cabinet Type and Port Position
Airmotiv T2+ has a rear firing port whereas S60 has a bottom firing ports. Polk S60's bottom-firing port gives more flexibility in placement in regards to proximity to walls compared to Emotiva Airmotiv T2+ with its rear-firing port.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare Emotiva Airmotiv T2+'s and Polk S60's external dimensions. Emotiva Airmotiv T2+ has external dimensions of 1085.0 x 310.0 x 439.0mm ( 42-11/16 x 12-3/16 x 17-1/4inch) whereas Polk S60 has external dimensions of 1131.0 x 299.0 x 401.0mm ( 44-1/2 x 11-3/4 x 15-3/4inch) .
Polk S60 is 11mm narrower and 38mm less deeper than Emotiva Airmotiv T2+ but it is also 46mm taller.
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the Emotiva Airmotiv T2+ is approximately 1360.9cm2 / 210.9inch2 and base area of the Polk S60 is approximately 1199.0cm2 / 185.8inch2. The Airmotiv T2+ requires 14% more surface area than the S60 which gives it a small disadvantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The Emotiva Airmotiv T2+ weighs 25.90kg / 57lbs and the Polk S60 weighs 23.60kg / 51.9lbs. This makes the Airmotiv T2+ 10% heavier than the S60.
Here is a comparison of how Airmotiv T2+ and S60's weights compare with the average, max and min weights in Passive Floor-standing class.
Weight
All Floor-standing Speakers
What's in the Box of Polk S60?
Here are the items that come with the S60:
Floorstanding loudspeakerGrille (attached)4 Feet (pre-installed)Owners ManualOnline Product Registration
Driver Setup |
3-way
vs
2-way
|
Have a dedicated mid-range driver |
Sensitivity |
91 dB
vs
90 dB
|
Play louder with same amount of amplification power |
Woofer Size |
8 inches
vs
6.5 inches
|
Larger woofer |
Height |
1085mm
vs
1131mm
|
Easier to fit in smaller spaces |
Max Input Power |
300 watts
vs
200 watts
|
Handle more power from your amplifier |
Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
Number of Woofers |
3
vs
2
|
More woofers |
Low Frequency Response |
26 Hz
vs
35 Hz
|
Generates deeper bass |
High Frequency Response |
40k Hz
vs
28k Hz
|
Generates higher frequency |
Base Surface Area |
1199cm2 (299x401mm)
vs
1360cm2 (310x439mm)
|
Takes less floor space |
Price per pair* |
898USD
vs
1099USD
|
costs less (*prices may change depending on the seller, location and time) |
General |
Emotiva Airmotiv T2+ |
Polk Audio Signature S60 |
Brand |
Emotiva |
Polk Audio |
Speaker Type |
Floor-standing speaker |
Floor-standing speaker |
Power Range |
Up to 200 watts |
20-300 watts |
Sensitivity |
91 dB |
90 dB |
Impedance |
4 ohms |
8 ohms |
Frequency Response |
35 Hz – 28 kHz |
26-40k Hz |
Drivers |
|
|
Woofer Quantity |
2 |
3 |
Woofer Size |
8" |
6.5" |
Woofer Composition |
woven fiber cone |
Mica-reinforced polypropylene |
Woofer Surround Material |
n/a |
Butyl rubber |
Tweeter Size |
25×32 mm" |
1" |
Tweeter Type |
folded ribbon |
Dome |
Aimable Tweeter |
No |
No |
Midrange Driver |
5.25" |
No |
Crossover Frequency |
350 Hz and 3200Hz |
2500Hz |
Firing Direction |
rear |
bottom |
Physical Specs |
|
|
Height |
1085.0mm (42.7") |
1131.0mm (44.5") |
Width |
310.0mm (12.2") |
299.0mm (11.8") |
Depth |
439.0mm (17.3") |
401.0mm (15.8") |
Weight |
25.90kg (57lbs) |
23.60kg (51.9lbs) |
Enclosure |
Bass reflex |
Bass Reflex |
Finish |
HDF |
Meddite MDF |
Available Colors |
Black |
Black |
Grille |
Yes |
Yes |
Moisture Resistancy |
No |
No |
Connections |
|
|
Biamp Inputs |
Yes |
Yes |
Other |
|
|
Parts Warranty |
5 Years |
5 Years |
Labor Warranty |
5 Years |
5 Years |