In this review, we will be comparing Muro SUB2010 and Sub 6, two Powered Subwoofer speakers from ELAC and Dynaudio. Being Powered subwoofers, they both have built-in amplifiers so you don't need an external power amp or an integrated amp to power them. Let's have a brief look at the main features of ELAC Muro SUB2010 and Dynaudio Sub 6 first before getting into our more detailed comparison.
In the following sections, we will get into details in order to better understand how the ELAC Muro SUB2010 and Dynaudio Sub 6 compare and hopefully end up with enough arguments to decide which one of these subwoofers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
The efficiency of a subwoofer is directly proportional to the total radiating are squared hence the woofer quantity and diameter.Both ELAC Muro SUB2010and Dynaudio Sub 6 have a single woofer setup however the ELAC Muro SUB2010's woofer is 8-inch whereas the Dynaudio Sub 6 features a 9.5-inch woofer.
Frequency Response
Muro SUB2010 has a frequency range of 38-150 Hz whereas Sub 6 has a frequency range of 16-230 Hz. With a minimum frequency of 16Hz, the Sub 6 can go significantly deeper on the low side and provide stronger bass compared to the Muro SUB2010's min frequency of 38Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Subwoofer class in our database.
Low Frequency
Subwoofer Speakers
High Frequency
Subwoofer Speakers
Cabinet Type
The ELAC Muro SUB2010 has a Bass Reflex type cabinet. Bass Reflex type subwoofers (aka Ported, Vented or Reflex Port) have enclosures that uses a port, hole or vent cut into the cabinet. Ported designs are generally more efficient than the Sealed designs. On the other hand the Dynaudio Sub 6 have Acoustic Suspension type enclosure. Acoustic Suspension aka Sealed type subwoofers have enclosures that are sealed hence no ports or holes exists on the cabinet. Sealed designs helps to provide more accurate and tight bass responses compared to ported designs.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare ELAC Muro SUB2010's and Dynaudio Sub 6's external dimensions. ELAC Muro SUB2010 has external dimensions of 388.0 x 135.0 x 405.0mm ( 15-1/4 x 5-5/16 x 15-15/16inch) whereas Dynaudio Sub 6 has external dimensions of 334.0 x 477.0 x 312.0mm ( 13-1/8 x 18-3/4 x 12-1/4inch) .
Dynaudio Sub 6 is 54mm shorter and 93mm less deeper than ELAC Muro SUB2010 but it is also 342mm wider.
Below you can see the front view size comparison of ELAC Muro SUB2010 and Dynaudio Sub 6 in scale.
Comparison image of ELAC Muro SUB2010 and Dynaudio Sub 6 Size and External Dimensions
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the ELAC Muro SUB2010 is approximately 546.8cm2 / 84.8inch2 and base area of the Dynaudio Sub 6 is approximately 1488.2cm2 / 230.7inch2. The Muro SUB2010 requires 63% less surface area than the Sub 6 which gives it a small advantage on placement in tight spaces.
Weight Comparison The weight of a subwoofer may become an important factor if you need to move and reposition the unit often to find the optimal positioning, also known as 'Subwoofer Crawling'. The ELAC Muro SUB2010 weighs 7.82kg / 17.2lbs and the Dynaudio Sub 6 weighs 20.55kg / 45.2lbs. This makes the Sub 6 163% heavier than the Muro SUB2010.
Here is a comparison of how Muro SUB2010 and Sub 6's weights compare with the average, max and min weights in Powered Subwoofer class.
Weight
All Subwoofer Speakers
What's in the Box of ELAC Muro SUB2010?
Here are the items that are included inside the box of Muro SUB2010:
Powered subwoofer6-feet AC power cord4 Cone feet2 Brackets2 Machine screws2 Wood screws2 Washers2 Wall anchorsOperating Instructions
What's in the Box of Dynaudio Sub 6?
Here are the items that come with the Sub 6:
Powered subwoofer2 Grilles6-feet AC power cord4 Rubber feet (pre-installed)4 Spike feet4 Hex-nuts4 Protective discsWrenchOwners ManualQuick Start GuideWarranty Extension CardWarning note
 App-Based Control |
iOS,Android
vs
None
|
Control the speaker via an app |
 Base Surface Area |
546cm2
vs
1488cm2
|
Takes less floor space |
 Wireless Operation |
Optional
vs
No
|
Connect your subwoofer to your system wireless |
 Woofer Size |
9.5 inches
vs
8 inches
|
Larger woofer |
| Low Frequency Response |
16 Hz
vs
38 Hz
|
Generates deeper bass |
 High Frequency Response |
230k Hz
vs
150k Hz
|
Generates higher frequency |
 Height |
334mm
vs
388mm
|
Easier to fit in smaller spaces |
| General |
ELAC Muro SUB2010 |
Dynaudio Sub 6 |
| Brand |
ELAC |
Dynaudio |
| Speaker Type |
Powered Subwoofer |
Powered Subwoofer |
| Max Amplifier Output |
125 watts |
500 watts |
| Frequency Response |
38-150 Hz |
16-230 Hz |
Amplifier |
|
|
| Watts RMS (Continuous) |
125-watt RMS |
500-watt RMS |
Drivers |
|
|
| Woofer Quantity |
1 |
1 |
| Woofer Size |
8" |
9.5" |
| Woofer Composition |
Polypropylene |
Magnesium Silicate Polymer |
| Tweeter Size |
- |
- |
| Aimable Tweeter |
No |
No |
| Midrange Driver |
No |
No |
| Firing Direction |
side or bottom |
side |
Physical Specs |
|
|
| Height |
388.0mm (15.3") |
334.0mm (13.1") |
| Width |
135.0mm (5.3") |
477.0mm (18.8") |
| Depth |
405.0mm (15.9") |
312.0mm (12.3") |
| Weight |
7.82kg (17.2lbs) |
20.55kg (45.2lbs) |
| Enclosure |
Bass Reflex |
Acoustic Suspension |
| Grille |
n/a |
Yes |
| Moisture Resistancy |
No |
No |
Connections |
|
|
Other |
|
|
| Parts Warranty |
1 Year |
3 Years |
| Labor Warranty |
1 Year |
3 Years |