In this review, we will be comparing Lumina CI and Monitor XT35, two Passive Center Channel speakers from Sonus Faber and Polk Audio. Let's have a brief look at the main features
of Sonus Lumina Center I and Polk XT35 first before getting into our more
detailed comparison.
What size room are the Sonus Lumina Center I and Polk XT35 speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the Sonus Lumina Center I and Polk XT35 compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
Both Lumina CI and Monitor XT35 are 2-way speakers.
Driver |
Sonus Lumina Center I |
Polk XT35 |
Driver Setup
|
2-way
|
2-way
|
Tweeter
|
1.15-inch
|
1-inch
|
Midrange
|
- |
- |
Woofer
|
2 x 4.75-inch
|
4 x 3-inch
|
Lumina CI features a 1.15" high definition DAD Tweeter and 2 x 4.75" paper cone Woofer with a Crossover frequency at 2000 Hz. On the other hand, the Monitor XT35 features a 1" Terylene High-res dome Tweeter and 4 x 3" bi-laminate paper cone Woofer .
Frequency Response
Lumina CI has a frequency range of 65-24k Hz whereas Monitor XT35 has a frequency range of 57-40k Hz. With a minimum frequency of 57Hz, the Monitor XT35 can go significantly deeper on the low side and provide stronger bass compared to the Lumina CI's min frequency of 65Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Center Channel class in our database.
Low Frequency
Center Channel Speakers
High Frequency
Center Channel Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Lumina CI is a 4 ohms speaker compared to the Monitor XT35 which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Lumina CI can provide this impedance level.
On the other hand, they have the same sensitivity of 87 dBdB.
Sensitivity
Center Channel Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Lumina CI can handle a max power of 200 watts RMS from the amp the whereas Lumina CI has a max power handling value of 100 watts RMS , 100 watts less than the Monitor XT35.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Lumina CI features Binding post posts which make bi-amping or bi-wiring possible. Monitor XT35 has a 5-Way post which doesn't feature bi-amping/bi-wiring.
Cabinet Type and Port Position
Lumina CI has a front firing port whereas Monitor XT35 has a rear firing ports. Sonus Lumina Center I's front-firing port gives more flexibility in placement in regards to proximity to walls compared to Polk XT35 with its rear-firing port.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare Sonus Lumina Center I's and Polk XT35's external dimensions. Sonus Lumina Center I has external dimensions of 169.0 x 524.0 x 213.0mm ( 6.6 x 20.6 x 8.4inch) whereas Polk XT35 has external dimensions of 107.0 x 621.0 x 142.0mm ( 4-3/16 x 24-7/16 x 5-9/16inch) .
Polk XT35 is 62mm shorter and 71mm less deeper than Sonus Lumina Center I but it is also 97mm wider.
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the Sonus Lumina Center I is approximately 1116.1cm2 / 173.0inch2 and base area of the Polk XT35 is approximately 881.8cm2 / 136.7inch2. The Lumina CI requires 27% more surface area than the Monitor XT35 which gives it a small disadvantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The Sonus Lumina Center I weighs 7.60kg / 16.7lbs and the Polk XT35 weighs 6.36kg / 14lbs. This makes the Lumina CI 19% heavier than the Monitor XT35.
Here is a comparison of how Lumina CI and Monitor XT35's weights compare with the average, max and min weights in Passive Center Channel class.
Weight
All Center Channel Speakers
What's in the Box of Sonus Lumina Center I?
Here are the items that are included inside the box of Lumina CI:
1 Center Channel Speaker1 Manual 2 Jumpers1 Grilles 1 Fabric dust guards
What's in the Box of Polk XT35?
Here are the items that come with the Monitor XT35:
Center-channel loudspeakerGrille (attached)4 Self-adhesive rubber feetOwners ManualOnline Product RegistrationWall-Mount Template
Woofer Size |
4.75 inches
vs
3 inches
|
Larger woofer |
Port Position |
Front
vs
Rear
|
Gives more flexibility placing close to walls |
Max Input Power |
200 watts
vs
100 watts
|
Handle more power from your amplifier |
Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
Number of Woofers |
4
vs
2
|
More woofers |
Low Frequency Response |
57 Hz
vs
65 Hz
|
Generates deeper bass |
High Frequency Response |
40k Hz
vs
24k Hz
|
Generates higher frequency |
Height |
107mm
vs
169mm
|
Easier to fit in smaller spaces |
Base Surface Area |
881cm2 (621x142mm)
vs
1116cm2 (524x213mm)
|
Takes less floor space |
Price per pair* |
299USD
vs
699USD
|
costs less (*prices may change depending on the seller, location and time) |
General |
Sonus Faber Lumina Center I |
Polk Audio Monitor XT35 |
Brand |
Sonus Faber |
Polk Audio |
Speaker Type |
Center channel speaker |
Low-profile center channel speaker |
Power Range |
30-100 watts |
25-200 watts |
Sensitivity |
87 dB |
87 dB |
Impedance |
4 ohms |
8 ohms |
Frequency Response |
65-24k Hz |
57-40k Hz |
Drivers |
|
|
Woofer Quantity |
2 |
4 |
Woofer Size |
4.75" |
3" |
Woofer Composition |
paper cone |
bi-laminate paper cone |
Tweeter Size |
1.15" |
1" |
Tweeter Type |
high definition DAD |
High-res dome |
Aimable Tweeter |
No |
No |
Midrange Driver |
No |
N/A" |
Crossover Frequency |
2000 Hz |
n/a |
Firing Direction |
front |
rear |
Physical Specs |
|
|
Height |
169.0mm (6.7") |
107.0mm (4.2") |
Width |
524.0mm (20.6") |
621.0mm (24.4") |
Depth |
213.0mm (8.4") |
142.0mm (5.6") |
Weight |
7.60kg (16.7lbs) |
6.36kg (14lbs) |
Enclosure |
Bass Reflex |
Bass Reflex |
Finish |
real multilayer wood |
n/a |
Available Colors |
Black, Wenge, Walnut |
Black |
Grille |
Yes |
Yes |
Moisture Resistancy |
No |
No |
Connections |
|
|
Biamp Inputs |
Yes |
n/a |
Other |
|
|
Parts Warranty |
|
5 Years |
Labor Warranty |
|
5 Years |