In this review, we will be comparing Airmotiv T1+ and S50, two Passive Floor-standing speakers from Emotiva and Polk Audio. Let's have a brief look at the main features
of Emotiva Airmotiv T1+ and Polk S50 first before getting into our more
detailed comparison.
What size room are the Emotiva Airmotiv T1+ and Polk S50 speakers good for?
The size of the room in which you are planning to use these loudspeakers is an important decision factor. Here we have compared their suitability to various sizes of environments considering their size and max power parameters:
In the following sections, we will get into more detail in order to better understand how the Emotiva Airmotiv T1+ and Polk S50 compare and hopefully end up with enough arguments to decide which one of these loudspeakers is the better choice for you.
**This post contains affiliate links, and I will be compensated if you make a purchase after clicking
through my links. As an Amazon Associate I earn from qualifying purchases.
Drivers
One of the fundamental differences between these two speakers is that Airmotiv T1+ is a 3-way design whereas the S50 is a 2-way speaker. 3-way designs utilize a midrange driver in addition to the tweeter and woofer on 2-way designs. Designing a crossover for a 3-way speaker is a complicated process and generally increases the overall cost of the speaker.
Driver |
Emotiva Airmotiv T1+ |
Polk S50 |
Driver Setup
|
3-way
|
2-way
|
Tweeter
|
25×32 mm-inch
|
1-inch
|
Midrange
|
1 x 5.25-inch |
- |
Woofer
|
2 x 6-inch
|
2 x 5.25-inch
|
Airmotiv T1+ features a 25×32 mm" folded ribbon Tweeter , a 5.25" Midrange and 2 x 6" woven fiber cone Woofer with a Crossover frequency at 275 Hz and 2700Hz. On the other hand, the S50 features a 1" Terylene Dome Tweeter and 2 x 5.25" Mica-reinforced polypropylene Woofer with a Crossover frequency at 2500Hz.
Frequency Response
Airmotiv T1+ has a frequency range of 37 Hz – 28 kHz whereas S50 has a frequency range of 33-40k Hz. With a minimum frequency of 33Hz, the S50 can go slightly deeper then the Airmotiv T1+'s min frequency of 37Hz.
Below graphs depict how these two speakers compare with the max, min and average values of the Min and Max Frequencies of other speakers in the Floor-standing class in our database.
Low Frequency
Floor-standing Speakers
High Frequency
Floor-standing Speakers
None of these speakers achieves full range experience which is commonly agreed as 20Hz-20kHz. In order to achieve lower lows / deeper bass, we recommend you pair these with a subwoofer. Visit our Powered Subwoofers section to find out more about the available options.
Impedance and Sensitivity
Airmotiv T1+ is a 4 ohms speaker compared to the S50 which has a nominal impedance of 8 ohms. Lower impedance speakers, especially the ones that are rated at 4 ohms may put more pressure on the amplifier unit especially when played at high volume levels, so make sure the amp you pair with the Airmotiv T1+ can provide this impedance level.
These two speakers also have different sensitivity levels. Airmotiv T1+ sensitivity is rated at 88 dB and the S50's is rated at 89 dB. This 1 dB difference makes the Polk S50 a more sensitive speaker compared to Emotiva Airmotiv T1+, hence will play louder with the same amount of watts.
Sensitivity
Floor-standing Speakers
Power Range
Power
range is the range of input power in watts RMS that a loudspeaker is designed to handle. While using an amplifier within this range ensures the nominal performance , inputting a power that is higher than the max wattage can result in a damaged speaker.
Keep in mind that a higher max power handling value doesn't necessarily make that a louder speaker
compared to a lower max handling speaker. Loudness or the sound level is also impacted by parameters
such as Impedance, sensitivity and system efficiencies.
Input Type and Bi-Amping / Bi-Wiring
Both Airmotiv T1+ and S50 features dual binding post speaker terminals for bi-amping or bi-wiring.
Cabinet Type and Port Position
Airmotiv T1+ has a rear firing port whereas S50 has a bottom firing ports. Polk S50's bottom-firing port gives more flexibility in placement in regards to proximity to walls compared to Emotiva Airmotiv T1+ with its rear-firing port.
Physical Specs
Size of a speaker can sometimes become an important decision factor due to space constraints or in some cases purely for esthetic reasons. In this section, we are going to compare Emotiva Airmotiv T1+'s and Polk S50's external dimensions. Emotiva Airmotiv T1+ has external dimensions of 1004.0 x 213.0 x 296.0mm ( 39-1/2 x 8-3/8 x 11-5/8inch) whereas Polk S50 has external dimensions of 951.0 x 262.0 x 281.0mm ( 37-7/16 x 10-5/16 x 11-1/16inch) .
Polk S50 is 53mm shorter and 15mm less deeper than Emotiva Airmotiv T1+ but it is also 49mm wider.
Base Surface Area Comparison
Base surface area of a loudspeaker may become a determining factor when the space in your room or desk is limited.
The base surface area of the Emotiva Airmotiv T1+ is approximately 630.5cm2 / 97.7inch2 and base area of the Polk S50 is approximately 736.2cm2 / 114.1inch2. The Airmotiv T1+ requires 14% less surface area than the S50 which gives it a small advantage on placement in tight spaces.
Weight Comparison The weight of a loudspeaker can become an important factor if you need to move and reposition the unit often. Weight of a speaker can also "sometimes" be an indicator of the rigidity of the enclosure and the quality of the internal components used. The Emotiva Airmotiv T1+ weighs 18.20kg / 40lbs and the Polk S50 weighs 14.50kg / 31.9lbs. This makes the Airmotiv T1+ 26% heavier than the S50.
Here is a comparison of how Airmotiv T1+ and S50's weights compare with the average, max and min weights in Passive Floor-standing class.
Weight
All Floor-standing Speakers
What's in the Box of Polk S50?
Here are the items that come with the S50:
Floorstanding loudspeakerGrille (attached)4 Feet (pre-installed)Owners ManualOnline Product Registration
Driver Setup |
3-way
vs
2-way
|
Have a dedicated mid-range driver |
Woofer Size |
6 inches
vs
5.25 inches
|
Larger woofer |
Base Surface Area |
630cm2 (213x296mm)
vs
736cm2 (262x281mm)
|
Takes less floor space |
Sensitivity |
89 dB
vs
88 dB
|
Play louder with same amount of amplification power |
Nominal Impedance |
8 ohms
vs
4 ohms
|
Less selective with amplifiers |
Low Frequency Response |
33 Hz
vs
37 Hz
|
Generates deeper bass |
High Frequency Response |
40k Hz
vs
28k Hz
|
Generates higher frequency |
Height |
951mm
vs
1004mm
|
Easier to fit in smaller spaces |
General |
Emotiva Airmotiv T1+ |
Polk Audio Signature S50 |
Brand |
Emotiva |
Polk Audio |
Speaker Type |
Floor-standing speaker |
Floor-standing speaker |
Power Range |
Up to 150 watts |
20-150 watts |
Sensitivity |
88 dB |
89 dB |
Impedance |
4 ohms |
8 ohms |
Frequency Response |
37 Hz – 28 kHz |
33-40k Hz |
Drivers |
|
|
Woofer Quantity |
2 |
2 |
Woofer Size |
6" |
5.25" |
Woofer Composition |
woven fiber cone |
Mica-reinforced polypropylene |
Woofer Surround Material |
n/a |
Butyl rubber |
Tweeter Size |
25×32 mm" |
1" |
Tweeter Type |
folded ribbon |
Dome |
Aimable Tweeter |
No |
No |
Midrange Driver |
5.25" |
No |
Crossover Frequency |
275 Hz and 2700Hz |
2500Hz |
Firing Direction |
rear |
bottom |
Physical Specs |
|
|
Height |
1004.0mm (39.5") |
951.0mm (37.4") |
Width |
213.0mm (8.4") |
262.0mm (10.3") |
Depth |
296.0mm (11.7") |
281.0mm (11.1") |
Weight |
18.20kg (40lbs) |
14.50kg (31.9lbs) |
Enclosure |
Bass reflex |
Bass Reflex |
Finish |
HDF |
Meddite MDF |
Available Colors |
Black |
Black |
Grille |
Yes |
Yes |
Moisture Resistancy |
No |
No |
Connections |
|
|
Biamp Inputs |
Yes |
Yes |
Other |
|
|
Parts Warranty |
5 Years |
5 Years |
Labor Warranty |
5 Years |
5 Years |